Interphase Tech U1-BBFF-DFN How can I set optimal operating parameters, What are preset modes?

Page 32

Fig. 6.1b - The 50-200 FISH FINDER (III)

6.2How can I set optimal operating parameters.

Optimal operating parameters can be set accordingly with the intended use of the Fish Finder, anyway to quickly get optimal operational parameters for fishing it is possible to select the FISH preset from the Fish Finder Setup menu, while for cruising it is possible to select the CRUISE preset.

6.3What are preset modes?

Preset modes are pre-defined settings of the Fish Finder operating parameters. You can use them to quickly set the Fish Finder in the most commonly used operating modes. These are:

♦CRUISE: sets the Fish Finder in full auto mode with the sensitivity set- tings (GAIN OFFSET, NOISE level and STC) optimized for displaying at best the bottom.

♦FISH: sets the Fish Finder in full auto mode with the sensitivity setting optimized for target searching.

6.4How can I restore the Fish Finder default operating

parameters?

Simply select the CRUISE or the FISH preset. This will restore optimal operating parameters for either cruising or fishing.

6.5Can I always leave the Fish Finder in Full Auto/(auto gain

and auto range) mode?

Yes, but note that the full auto mode suits the 90% of the cases, however in extreme situations the auto modes mail fail and thus it is necessary to switch to the Manual mode.

6.6What are extreme situations in which auto modes may

fail?

When the bottom is very deep, at high boat speed, when the bottom is very shallow (< 5 feet), when the water is full of materials in suspension, with bad sea conditions.

34

User Manual

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Fish Finder Contents Fish Finder Important Information Warrranty StatementIntroduction Conventions UsedFrequently Asked Questions If YOU Need AssistanceOverview Fish FinderFish Finder Features & FunctionsOverview Selecting the Fish Finder Port Fish Finder Understanding the Fish FinderFish Finder Display Color BarUnderstanding the Fish Finder Display How to select the Fish Finder Displaying the Fish FinderFish Finder Full Display Menu keyCursor key Enter key3 50/200 kHz Full Display Zoom Full DisplayClear key Zoom in and Zoom OUT keysChart/Fish Display Menu key to change the active windowMarker Zoom Zoom ModesBottom Lock Zoom System Update menu Info on Fish Finder System InformationSetup your Fish Finder Fish Finder Setup MenuDepth ShiftFrequency Interference RejectionDisplay Setup Fish SymbolsSTC Length STC StrengthWater Temperature Transducer SetupCalibrate Water Temperature Calibrate Aux TemperatureTemperature Upper Temperature LowerTemperature Rate Fish AlarmPage Technical Specifications TEMP2Mounting the Fish Finder DimensionsInstallation Installing Optional Devices Status LEDPower Supply Wiring Diagram External ConnectionsChart Plotter Connection Diagram BLUPage Transducers Page Frequently Asked Questions 1a The 50-200 Fish FinderWhat are extreme situations in which auto modes may Fail? What are preset modes?How can I set optimal operating parameters Eliminate it? What should I do if the auto modes fail?Should I do? Screen clutter? Why do I never see fish in the range between 0 to Meters?How can I reduce the surface clutter? Alarm 10, 12, 22 Index
Top Page Image Contents