Interphase Tech U1-BBFF-DFN user manual Status LED, Installing Optional Devices

Page 25

Fig. 4.3.1 - The 50-200 FISH FINDER Installation

♦Fix the 50-200 FISH FINDER to the mounting location using the four screws (holes diameter 4 mm), see Fig. 4.3.2.

♦Route the CHART PLOTTER cable to the chart plotter.

♦Mount the transducer according to the instructions provided with it.

♦Connect the POWER cable to the battery. Please be advised that the 50-200 FISH FINDER when not operating will remain in Stand-By mode.

4.3.2Installing Optional Devices

See the External Connection diagram.

4.4STATUS LED

There are seven different LED behaviors, representing seven different diagnostic conditions. These are described below.

♦OFF

The 50-200 FISH FINDER is running in the boot loader, or DC power is not being supplied to the 50-200 FISH FINDER.

♦ON, CONTINUOSLY

The transducer is not connected to the chart plotter or problem with cable of the transducer cable.

♦1 long flash every 2 seconds

The 50-200 FISH FINDER is not connected with the chart plotter.

♦1 short flash every 2 seconds

The 50-200 FISH FINDER is connected to the chart plotter and is oper- ating correctly.

♦2 short flashes every 2 seconds

The 50-200 FISH FINDER is not operating as it is waiting for a com- mand from the chart plotter.

♦3 short flashes every 2 seconds

A transducer (without transducer ID) has been connected.

♦4 short flashes every 2 seconds: No transducer connected.

User Manual

27

Image 25

Contents Fish Finder Contents Fish Finder Warrranty Statement Important InformationConventions Used IntroductionIf YOU Need Assistance Frequently Asked QuestionsOverview Fish FinderOverview Features & FunctionsFish Finder Selecting the Fish Finder Port Understanding the Fish Finder Fish FinderFish Finder Display Color BarUnderstanding the Fish Finder Display Displaying the Fish Finder How to select the Fish FinderMenu key Fish Finder Full DisplayCursor key Enter keyZoom Full Display 3 50/200 kHz Full DisplayClear key Zoom in and Zoom OUT keysMenu key to change the active window Chart/Fish DisplayBottom Lock Zoom Zoom ModesMarker Zoom Info on Fish Finder System Information System Update menuFish Finder Setup Menu Setup your Fish FinderShift DepthFrequency Interference RejectionFish Symbols Display SetupSTC Length STC StrengthTransducer Setup Water TemperatureCalibrate Water Temperature Calibrate Aux TemperatureTemperature Lower Temperature UpperTemperature Rate Fish AlarmPage TEMP2 Technical SpecificationsInstallation DimensionsMounting the Fish Finder Status LED Installing Optional DevicesExternal Connections Power Supply Wiring DiagramBLU Chart Plotter Connection DiagramPage Transducers Page 1a The 50-200 Fish Finder Frequently Asked QuestionsHow can I set optimal operating parameters What are preset modes?What are extreme situations in which auto modes may Fail? Should I do? What should I do if the auto modes fail?Eliminate it? How can I reduce the surface clutter? Why do I never see fish in the range between 0 to Meters?Screen clutter? Index Alarm 10, 12, 22