GE DPGT650, UPGT650 operating instructions Before you call for service…, Normal Operating Sounds

Before you call for service… GEAppliances.com

Troubleshooting Tips

Save time and money! Review the chart below first and you may not need to call for service.

Problem	Possible Cause	What To Do
Dryer won’t	Control panel is asleep	• This is normal. Press POWER.
operate
	Dryer is unplugged	• Make sure cord is plugged securely into a working outlet.
	Controls are not set properly	• Make sure the cycle was set correctly, close the lid and
		press START.
	Fuse is blown/circuit breaker	• Check house circuit breakers/fuses. Replace fuses or reset
	is tripped	breaker. NOTE: Electric dryers use two fuses or breakers.
	Electronics need to be reset	• Unplug dryer, wait 2 minutes, plug back in and press POWER.
	START was not pressed after	• Press START.
	a cycle was set
	Door was opened during the	• Close the door and reset cycle, to the beginning if necessary.
	dry cycle	Press START.
	Dryer is too cold	• If the dryer has been exposed to temperatures below freezing
		for an extended period of time, allow it to warm up before
		pressing POWER. Otherwise, the display will not come on.

Normal Operating Sounds

The following are normal sounds you may hear:

Sound	Description
Thumping noise when	• If the dryer has not been used for an extended period of time, you may hear a thumping noise
drum rotates	from temporary flat spots on the drum support rollers. The noise will go away after use.

33

Safety Instructions Operating Instructions

Instructions Installation

Troubleshooting Tips Consumer Support