Furuno FA-150 installation manual How to attach the connector N-P-8DFB for cable 8D-FB-CV

Page 8

How to attach the connector N-P-8DFB for cable 8D-FB-CV

Outer Sheath

Dimensions in millimeters.

Armor

Inner Sheath Shield

 

50

30

Cover with heat-shrink tubing and heat.

Remove outer sheath and armor by the dimensions shown left.

Expose inner sheath and shield by the dimensions shown left.

Cut off insulator and core by 10mm.

30

10

Clamp

Gasket Clamp

Nut

(reddish

 

brown)

 

Aluminum Foil

Trim shield here.

Insulator

Trim aluminum tape foil here.

Twist shield end.

Slip on clamp nut, gasket and clamp as shown left.

Fold back shield over clamp and trim.

Cut aluminum foil at four places, 90° from one another.

Fold back aluminum foil onto shield and trim.

1

5

Pin

Clamp Nut

Shell

Solder through the hole.

Expose the insulator by 1mm.

Expose the core by 5mm.

Slip the pin onto the conductor. Solder them together through the hole on the pin.

Insert the pin into the shell. Screw the clamp nut into the shell.

(Tighten by turning the clamp nut. Do not tighten by turning the shell.)

How to attach connector N-P-8DFB

2

Image 8
Contents Uais Transponder 00015008314 Safety Instructions System Configuration Category of the unitsIii Equipment ListsStandard supply Optional supply Mounting Antenna UnitsGPS antenna unit Extending antenna cableHow to attach the connector N-P-8DFB for cable 8D-FB-CV How to attach connector N-P-8DFBVHF antenna Location CablingHorizontal separation distance 3 GPS/VHF combined antenna How to attach the plug M-P-7Installation overview of GPS/VHF combined antenna Mounting procedure GPS/VHF Combined antennaInstalling distributor unit DB-1 Flush mounting Monitor UnitDesktop mounting Type Name Type Code No QtyUais Transponder MountingPower Supply option Pilot Plug optionWiring ConnectionInternal ports of the Transponder Cable connection at transponder Fabrication of cables TTYCS-4, TTYCS-1Q and TTYCS-1How to attach wires to the Wago connector Fabrication of power cable DPYC-2.5Changing Ship’s Mains Specifications 100-115 VACEntering activation key Setting and AdjustmentInland AIS Specific Settings Selecting AIS mode Setting blue sign statusPassword entry window NAV Status menu initial sub-menuInitial Settings menu SET Blue Sign SW sub-menuSetting MMSI, IMO No., Name and Call Sign SET Mmsi sub-menuSetting GPS Antenna Position Setting Ship Type Setting I/O PortSetting COM port/PC port Table Ship typePress the ENT key again to display the Mode setting window COM1 Long Range Priority setup Priority menuQuality setup Inland AIS only Attaching LAN KIT Option AttachingSetting LAN port for PC network Setting LAN port for Navnet 3D networkContinuous This page intentionally left blank IEC 61162-1/2 Data Sentences TransponderInput data/Sentences Output data/SentencesInland AIS specific sentences Input+056#..#6+10/#64+#.5 # 8# #%%5514+5 Antenna Cable Set CP20-02700 CP20-02710 Antenna Cable Set CP20-00300 CP20-00310 Page Page Page Hatai Mar,2707 R.Esumi May 20 Page Jan 26/Oct/09 R.Esumi Page Page Page Page Page Transponder Unit
Related manuals
Manual 54 pages 24.96 Kb