Fixing holes inside antenna unit

1. MOUNTING

This method requires removal of the RF unit in the antenna unit to access inside fixing holes. Use hex head bolts, flat washers, spring washers and nuts (local supply) to mount the antenna unit, confirming length of bolts.

1.Loose four hex. bolts to open the antenna unit. Refer to Figure 1-10 for location.

Hex head bolt	Upper chassis
M8X25
2pcs.

RFunit

Hex head bolt

M10X20 4pcs.

Spring Washer

M10 4 pcs.

Cover

Pan head screw M3X8 4pcs.

Square bushing

Lower chassis

Figure 1-9 Antenna unit chassis, upper chassis separated

2.Unplug connector connected between upper and lower chassis.

3.Separate upper chassis from lower chassis by removing two hex head bolts.

4.Remove cover by unfastening four pan head screws.

5.Remove connector from RF unit.

6.Remove RF unit by unfastening four hex head bolts.

7.Lay the corrosion-proof rubber mat (supplied) on the mounting platform.

8.Fasten the lower chassis to the mounting platform with hex head bolts, spring washers, flat washers and nuts (local supply), and then coat flat washers, nuts and exposed parts of bolts with silicone sealant. Cut a slit in rubber bushing and insert bolt into bushing. Do not use seal washers.

9.Reassemble RF unit, cover and upper chassis.

10.Set four caps (supplied) into outside fixing holes.

11.Do steps 6-8 in “Outside fixing holes”.

1-6