•This device does not include an internal Ground Fault Circuit Interrupter (GFCI).
•Use only
WARNING: Pursuant to California Proposition 65, this product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling.
2.INVERTER FEATURES
1.LED Indicator Light
(Green = Power ON, Red = Overload, Alarm)
2.Standard Electrical 120V AC Outlet
3.
4.USB Power Port
5.
3.BEFORE USING YOUR POWER INVERTER
When you turn on a device or a tool that runs on a motor, the device basically goes through two stages:
1.Start Up – Requiring an initial surge of power (commonly known as the “starting or peak load”).
2.Continuous Operation – Power consumption drops (commonly known as the “continuous load”).
The wattage (WATTS) or amperes (AMPS) can normally be found stamped or printed on most devices and equipment, or in the user’s manual. Otherwise, contact the manufacturer to find out whether the device you want to use is compatible with a modified sine wave.
To calculate the wattage: Wattage = AMPS x 120 (AC Voltage).
To calculate the starting load: Starting Load = 2 x WATTS. In general, the start up load of the device or power tool determines whether your inverter has the capability to power it.
To calculate the continuous load:
Continuous Load = AMPS x 120 (AC Voltage).
ATTENTION: Always run a test to establish whether the inverter will operate a particular piece of equipment or device. In the event of a power overload, the inverter is designed to automatically shut down.
• 2 •