Sterling SSC1-5Q service manual Work Rules, Tools and Equipment Needed, Safety Considerations

Page 12

2

Safety

 

 

2-1 Work Rules

The installation, operation, and maintenance of this equipment must be conducted in accordance with all appli- cable work and safety codes for the installation location. This may include, but is not limited to OSHA, NEC, CSA, SPI, and any other local, national, and international regulations.

;Read and follow these operating instructions when installing, operating, and maintaining this equipment. If the instructions become damaged or unreadable, additional copies are available from Sterling.

;Only qualified personnel familiar with this equipment should work with this system.

;Work only with approved tools and devices.

;Disconnect and lock out power while working on this equipment.

2-2 Tools and Equipment Needed

These tools and equipment are necessary for installation:

;

;

Hand tools.

Wire, conduit, and fittings for wiring runs.

;Anchor bolts with nuts and washers or red head-type anchors.

2-3 Safety Considerations

The terms NOTICE, CAUTION, WARNING, and DANGER have specific meanings in this manual.

NOTICE is used to indicate a statement of company policy directly or indirectly related to the safety of personnel or protection of property.

CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor injury.

WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Page 11 of 38

Image 12
Contents SSC1-5Q Parts and Service Department Model # Serial # Table of Contents Configurable Settings Charts and Figures Safety Considerations Sterling SSC1-5Q Conveying Systems Pump 5-Station Controller General Information Equipment FunctionNecessary Documents System CapabilitiesEquipment Cycle Models Covered by this ManualSSC1-5Q 5-Station Controller SSC1-5Q Controller Safety Safety ConsiderationsWork Rules Tools and Equipment NeededReporting a Safety Defect General ResponsibilityMaintenance Responsibility Operator ResponsibilitySafety Devices Safety Circuit StandardsFail Safe Operation Safety Device Lock-Outs Page Shipping Information Unpacking and InspectionEvent of Shipping Damages Parcel Post ShipmentUnited Parcel Service Shipment If the Shipment is Not CompleteIf the Shipment is Not Correct ReturnsInstallation Installing the SCC1-5Q Control PanelMaking SSC1-5Q Control Panel Power Drop Wiring Connections Connecting the Control Panel to Vacuum ReceiversConnecting the Control Panel to the Pump Package Special Timed ConveyUsing the Controller SetupBasic Menus and Setup of Controller IntroductionSetting Pump Parameters Setting Blowback ParametersChanging Parameters Starting the SystemHigh vaccum alarm will sound in Short Tones Long Tones6Configurable Settings Options for Station SetupOptions for Pump Setup Idle7Maintenance Troubleshooting General TroubleshootingAlarms Station AlarmsPump Alarms Remote Audible/visual alarm Options230/1/60 Operation CE Package for 220/1/50 OperationSpare Parts List Recommended Spare Parts ListTechnical Assistance Contact Information for Technical AssistanceWarranty Returns Returned Material PolicyCredit Returns Warranty Safety Tag Information Controller Safety TagsController Identification Serial Number Tag Appendix Page Service Department