Basic Installation Procedures
Step 3: Mounting the Unit
To mount the Freedom HF:
1.Remove the Freedom HF from its shipping container, verify that all components are present, and record relevant product information on “Information About Your System” in the Owner’s Guide.
2.Select an appropriate mounting location and orientation. (See Figure 2 below.) To meet regulatory requirements, for use in
•Under a horizontal surface (see 1)
•In a horizontal position on a vertical surface (see 2)
NOTE: For marine installations, only this orientation is allowed, due to the probability of moisture finding access into the enclosure.
1 |
2 |
3
See page 31 for drip shield installation on Marine applications.
•On a horizontal surface (see 3)
Figure 2 Approved Mounting Orientations
3.Look for the mounting template and unfold. Tape it to the mounting surface and
4.Fasten the Freedom HF to the mounting surface. If you are mounting the unit on a wall or bulkhead, use #12 or #14
Alternatively, use nut inserts and
12 | Freedom HF Installation Guide |