Marine Installation
Figure 1 illustrates a typical marine installation with the following components:
1.AC power supplied from a shore power connector
2.An AC source panel that includes a Max 30A circuit breaker that supplies the Freedom HF
3.An AC load panel with branch circuit breakers that supply only loads that run off the Freedom HF
4.Engine negative bus / DC ground bus
5.DC power supplied by a battery bank and protected by a DC fuse in the positive cable
6.Battery isolator
7.DC alternator
8.Starting battery
9.Drip shield (not shown)
DC Fuse / disconnect or circuit breaker
12V Deep Cycle
Battery
Starting Battery
AC Load Panel
AC Source Panel
Shorepower
Figure 1 Typical Marine Installation
34 | Freedom HF Installation Guide |