Baja Marine 30 manual Safety Hotlines, Collisions and Leaking, Grounding

Page 22

Section 1 • Safety

E.Collisions and Leaking

In the event of collisions and leaking:

Slow down or stop to reduce water intake, unless maintaining speed will keep the hole above water.

Switch on bilge pump.

Operate manual bilge pump, if the powered bilge pump can't handle the water flow.

Account for everyone on board and check for injuries.

Have everyone put on PFDs.

Stay with the boat.

Signal for help.

If a leak patch is attempted, it should be done from the outside.

In the event of a collision, you are required to file an accident report. Contact a state enforcement agency or the nearest Coast Guard office. If you are boating outside of U.S. waters, consult the nation you are visiting for accident reporting requirements.

F.Grounding

In the event of running aground:

Check for leaks. If water is coming in, stop the intake of water before attempting to get the boat free.

Inspect for damage to the hull, propulsion and steering systems.

Determine if the tide, wind and current will drive the boat harder aground or will help to free it.

Determine the water depth all around the boat, and the type of bottom (sand, mud, rocks, etc.). If it can be done without exposing persons to a risk

of injury, the boat should be moved away from hard obstructions, and toward open water with soft ground.

Do not attempt to have your boat towed by other than a trained and competent service, such as the Coast Guard or a salvage company. Recreational craft are not designed to tow other recreational craft.

G.Propulsion, Control or Steering Failure

If the drive train fails, or the controls or steering do not respond properly or at all:

Shut off engine.

Put out the anchor to prevent drifting.

Determine whether or not you can repair the problem yourself. See the proper manuals for assistance in troubleshooting the engine, steering and engine controls.

If you are not sure you can fix the problem, or if conditions are adverse, signal for help.

17.Safety Hotlines

The safety information in the preceding pages gives only the general areas of concern for boating safety. It is not intended to be, nor can it be, exhaustive. You must take a boating safety course, and get hands-on instruction in the proper and safe operation of your boat from experienced persons before cruising.

The U.S. Coast Guard offers many pamphlets on safety and other information not covered in this manual. Contact your local Coast Guard unit or call the toll-free safety hotlines below for information.

U.S. Coast Guard 1-800-368-5647

Canadian Coast Guard 1-800-267-6687

It is recommended that these and other important numbers be stored in your cell phone for quick reference.

In other countries, ask your marine dealer for information on how to contact the national boating law enforcement agency.

30 Outlaw®

1.12

Image 22
Contents Baja Marine OutlawFor information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction HIN Number Hull Identification Number HINAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationPropellers Power CapacityLoad Capacity United StatesStability Maintain ControlWeather Chart Your CourseGeneral Considerations Swimming Water SportsSkiing Emergency Situations GeneralFire Medical EmergencyWater Rescue Flooding, Swamping and CapsizingGrounding Safety HotlinesCollisions and Leaking Propulsion, Control or Steering FailureEnvironmental Considerations International RequirementsFuel and Oil Spillage Wake/Wash Waste DisposalExcessive Noise Nautical Terms Key to Symbols on Controls & Prints This Page Intentionally Left Blank Baja Marine Corp This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemGeneral Deck Layout Description of Major Controls Power Trim Unit and GaugeGear Shift and Throttle Control Trailer Switch Trim TabsImportant Gauges Ignition Shutdown SwitchEngine Alarm System Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Power SteeringHydraulic Steering Fuel & Oil Spillage Bilge & Underwater GearBilge Drain PlugBilge Blowers Maintenance and ServiceEngines and Stern Drive Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Before and During Fueling Checklist Fueling PrecautionsStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Direct Current DC Electrical SystemsElectrical Systems BatteriesBreakers and/or Fuses Electrolytic Corrosion & Zinc AnodesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Drive Pump Drive Pump w/ K-Plane Trim Tabs Ignition Switch Switch Panel Wire Information FIG This Page Intentionally Left Blank Options & Accessories Options & Accessories LocationsFire Extinguisher Port Automatic Fire Extinguisher System OptionCanvas Depth Finder Optional Canvas Care and MaintenanceSwim Platform w/ Ladder Optional HornPortable Head with Pump-Out Stereo SystemHead Systems Requirements for OperatorsHolding Tank Operation Exhaust SystemsVacuFlush Head Option Vent FilterSummary Guide for Inspection, Service and Maintenance Required Inspection, Service MaintenanceInterval Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaTopside and Supplies Winterization Checklist for Boats Stored on LandBatteryies Boat StorageFuel System Fitting Out After StorageFuel Systems MiscellaneousPower Steering System Maintenance Security ConsiderationsBoarding the Boat General Quick Reference ChecklistBoat Systems Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralSecuring the Boat Quick Reference Checklist cont’dIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Stains & Scratches Paint Cleaning Agents & Other SubstancesCare & Refinishing Fiberglass & GelcoatAcrylic Plastic Sheeting Plastic Glass Permanently Moored or Docked BoatsTopside Areas Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Outlaw