Multiquip QP3TZ manual Preparation for LONG-TERM Storage, Pump Storage

PREPARATION FOR LONG-TERM STORAGE

Pump Storage

For storage of the pump for over 30 days, the following is required:

Drain the fuel tank completely.

Run the engine for about 3 minutes and then stop.

Stop the engine. Drain the engine crankcase oil while the engine is still warm. Fill engine crankcase with fresh oil.

Pull the recoil starter grip (Figure 17) 2 or 3 times. DO NOT start the engine.

Pull the recoil starter grip slowly. STOP when it feels tight. This closes the intake and exhaust valves (compression position) , and helps prevents rust from forming.

Wipe any oil or dirt that may have accumulated on the engine.

Remove the drain plug from the pump and drain out any water left in the housing.

Remove the pump cover and clean the inside of pump housing. Coat the inside of pump housing with a light film of oil to reduce corrosion. A spray can of oil works well for this application.

Cover suction and discharge ports with duct tape to prevent any foreign matter from falling into pump.

Cover pump and engine with plastic covering or equivalent and store in a clean, dry place.

To protect the water cooled-seals, place one-half pint of lubricating oil (new or used) through the discharge opening on the pump and crank the engine several times. This will prevent excessive corrosion and also keep the mechanical seal lubricated.

Figure 17. Recoil Starter Grip

QP3TZ TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #3 (10/21/11) — PAGE 23