Multiquip QP3TZ manual Fuel Safety

Page 9

SAFETY INFORMATION

FUEL SAFETY

DANGER

„DO NOT add fuel to equipment if it is placed inside truck bed with plastic liner. Possibility exists of explosion or fire due to static electricity.

„DO NOT start the engine near spilled fuel or combustible fluids. Fuel is extremely flammable and its vapors can cause an explosion if ignited.

„ALWAYS refuel in a well-ventilated area, away from sparks and open flames.

„ALWAYS use extreme caution when working with flammable liquids.

„DO NOT fill the fuel tank while the engine is running or hot.

„DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system.

„Store fuel in appropriate containers, in well-ventilated areas and away from sparks and flames.

„NEVER use fuel as a cleaning agent.

„DO NOT smoke around or near the

equipment. Fire or explosion could result from fuel vapors or if fuel is spilled on a hot engine.

BATTERY SAFETY (ELECTRIC START ONLY)

DANGER

„DO NOT drop the battery. There is a possibility that the battery will explode.

„DO NOT expose the battery to open flames, sparks, cigarettes, etc. The battery contains combustible gases and liquids. If these

gases and liquids come into contact with a flame or spark, an explosion could occur.

WARNING

„ALWAYS wear safety glasses when handling the battery to avoid eye irritation. The battery contains acids that can cause injury to the eyes and skin.

„Use well-insulated gloves when picking up the battery.

„ALWAYS keep the battery charged. If the battery is not charged, combustible gas will build up.

„DO NOT charge battery if frozen. Battery can explode. When frozen, warm the battery to at least 61°F (16°C).

„ALWAYS recharge the battery in a well-ventilated environment to avoid the risk of a dangerous concentration of combustible gases.

„ If the battery liquid (dilute sulfuric acid) comes into contact with clothing or skin, rinse skin or clothing immediately with plenty of water.

„If the battery liquid (dilute sulfuric acid) comes into contact with eyes, rinse eyes immediately with plenty of water and contact the nearest doctor or hospital to seek medical attention.

CAUTION

„ALWAYS disconnect the NEGATIVE battery terminal before performing service on the equipment.

„ALWAYS keep battery cables in good working condition. Repair or replace all worn cables.

QP3TZ TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #3 (10/21/11) — PAGE 9

Image 9
Contents Model QP3TZ Diesel engine exhaust and some Proposition 65 WarningQP3TZ Trash Pump Operation and Parts Manual REV. #3 10/21/11 MQ QP3TZ Trash Pump Hatz 1B30 Diesel Engine Table of ContentsOrdering parts has never been easier Parts Ordering ProcedureSafety Messages Safety InformationGeneral Safety Engine Safety Fuel Safety Transporting Safety Specifications Pump SPECIFICATIONS/DIMENSIONS PumpEngine Specifications Hatz 1B30 Specifications EngineApplication General InformationGeneral dewatering applications. Typical dewatering ComponentsInitial Servicing Basic EngineBefore Starting InspectionHoses and Clamps Understood OperationPump Vacuum Test MaintenancePump Vacuum Tester Engine Maintenance Schedule Daily Pump Storage Preparation for LONG-TERM StorageTroubleshooting Engine TroubleshootingSymptom Xxxxx only Not Used on Explanation of Code in Remarks ColumnQP3TZTRASH Pump Suggested Spare PartsPump Assy Casing Pump AssyCasing Cover Suction CoverPump Assy Bolt SET W/ Spring Washer Suction Cover M8 X Bolt SET W/ Spring Washer Suction Plate M8 XStud Bolt Drain Cover Handle KEY, ImpellerSpare Parts Kits Assy Gasket SET CYL. Head Gasket SET CrankcaseEmergency KIT Accessories Assy Decal Maintenance Accessories AssyTool KIT Decal StartCrankcase and Engine Mount Assy Crankcase and Engine Mount Assy Maintenance KITIncludes Items W Not Sold SeparatelyCrankshaft Assy Stubshaft no SAE GEN Closing Plug 12 MMStubshaft TAP 25 DIA Stubshaft no 1 DIACamshaft Assy Camshaft Assy FlyweightCamlever Lock WasherPiston Assy Circlip Piston AssyPiston PIN Piston Ring SET 80MM Not Sold SeparatelyCylinder Head Assy Cylinder Head Assy Cylinder Head Cover Maintenance KITValve Guide Stud Cylinder Head 141MMOIL PUMP/GOVERNOR Assy Retaining Strap OIL PUMP/GOVERNORBall 3.5MM ALL. Screw M5X12OIL PUMP/GOVERNOR Assy Ring Centrifugal WeightThreaded PIN M6X35 AS Required Threaded PIN M6X18 AS RequiredTiming Cover Assy Closing Plug Bolt Governor HousingMain Bearing BallFlywheel Assy Blower Ring Flywheel AssyALL. Screw M4X20 Spring Washer A4Fuel Injection Assy Shim 1.00MM Sealing ConeShim 1.04MM Shim 1.10MMFuel Injection Assy Fuel Injection Assy Connecting NippleControl Sleeve Shim 0.2MMRecoil Starter Assy Rubber Sleeve Housing Recoil StarterReturn Spring Allen Screw M6X10AIR Duct Assy Hood AIR Duct AssyBlower Ducting Disc A6,4AIR Duct Assy Stud M6X45 TubeSealing Strip 48MM Stud M6X35Crankcase Breather Assy Crankcase Breather Assy Filter Breather SystemSuction Pipe Fuel Tank ASSY. OLD Style CAP for Fuel Tank Fuel Tank ASSY. OLD StyleFuel Hose Fuel PipeFuel Tank ASSY. NEW Style Rope Fuel Tank ASSY. NEW StyleClamp Gasket for Fuel CAPFuel Tank ASSY. NEW Style INSUL. Hose 7 Seal WireHouse Clip Water SeparatorAIR Filter Assy AIR Filter AssyALL. Screw M8X25 Sealing StripNUT M6 Cover AIR FilterMuffler Assy Threaded Bolt M6 Exhaust END PipeExhaust Tube CTR. Sunk Screw M6X12Sealing and Bonding Adhesives Sealing and Bonding AdhesivesFreight Policy Terms and Conditions of Sale PartsHERE’S HOW to GET Help