Multiquip GB4000 manual Symptom Possible Problem Solution, Location of Maintenance Parts

Page 28

 

 

MAINTENANCE

 

 

 

 

 

 

 

Table 3. Troubleshooting

 

SYMPTOM

POSSIBLE PROBLEM

SOLUTION

 

Is plug disconnected?

Plug in correctly.

 

Is generator power switched off?

Turn on switch.

Lamp does not light.

Is lamp loose?

Screw lamp securely into socket.

Is power connector disconnected or

Connect disconnected connector.

 

 

loose?

 

 

 

Is model of lamp incompatible?

Use genuine MQ lamp.

Lamp only lights for a short time.

Is ambient temperature too high -

Move lamp where there is proper

more than 104° F (40° C)?

ventilation.

 

 

Is fan motor not working properly?

Check and repair fan motor.

Balloon does not inflate.

Is balloon cloth defective?

Repair or replace balloon cloth.

 

Is Lamp 1 on but fan is not working?

Check and repair fan motor.

Only Fan is working.

Is Lamp 1 not turning on?

Check Lamps and cable wiring.

Shuts down after 30 seconds.

Is Microswitch being pressed?

Check Microswitch or repair fan motor.

LAMP 1

MICRO SWITCH

LAMP 1

Figure 24. Location of Maintenance Parts

PAGE 28 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)

Image 28
Contents Model GB4000 This Manual Must Accompany the Equipment AT ALL TimesPage Page Table of Contents GB4000 Balloon LightParts Ordering Procedures Ordering parts has never been easierSafety Messages Safety InformationSafety Symbols General Safety Light Tower Safety Lamp SafetyEngine Safety Any enclosed or narrow areaFuel Safety Towing Safety Light TowerTransporting Safety  Never lift the equipment while engine is runningElectrical Safety  Never operate GB4000 in winds in excess of 40 MPH 64 km/hBattery Safety Environmental SafetySpecifications SpecificationsDimensions Closed OpenedFootcandle Plot Footcandle PlotGeneral Information Components GB4000 ComponentsPower Disconnection SetupPreparation Remove the adapter plate kit hardware from its container Lock Washer HEX NUT Junction BOX Mounting Balloon Power CableLamp Mounting Lamp Cable Connections GB4000Removing Balloon Protective Cover OperationInflating Balloon and Turning on Lamps LT12 only Inflating Balloon and Turning on Lamps MLT only Deflating and Storing BalloonReplacing Lamp Maintenance\ Caution Replacing Balloon Unzipping BalloonSymptom Possible Problem Solution Location of Maintenance PartsWiring Diagram Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts GB4000 Balloon Light 1 to 3 unitsNameplate and Decals 120V 60Hz 4000 WPart Name QTY. Remarks Decal WARNING, Burn Hazard FrenchElectrical Assy Part Name QTY Remarks PlateElectrical Assy Part Name Bracket and J-BOX Assy BOX Relay Terms and Conditions of Sale Parts Freight PolicyPage HERE’S HOW to GET Help