Multiquip GB4000 manual Remove the adapter plate kit hardware from its container

Page 20

SETUP

LAMP ADAPTER PLATE MOUNTING INSTALLATION

1.Remove the adapter plate kit hardware from its container.

2.Before proceeding make sure the light tower mast is in the stow position (down) and the cradle lock/release pin has been inserted and the mast is locked.

3.Attach the lamp adapter plate to the T-Bar as shown in Figure 7. Align adapter plate so that adapter spacer notch fits over screw on T-Bar. Pay close attention to the orientation of the two support brackets.

4.Mount the flat end of both support brackets flush against the T-Bar with the low end of each bracket facing inwards toward the mast. The raised end of each bracket should be facing outward.

NOTICE

Pay close attention to the orientation of the two support brackets. Each bracket has a high and low side.The low side of the bracket should be facing inwards towards the mast.

5.Next, insert a bolt (4) and flat washer (4) thru the mounting holes on the adapter plate as shown in Figure 7. Again, pay close attention on which set of holes to insert the bolts thru. Bolt number 2 must be oriented so that it passes between receptacles J1 and J2 on the T-Bar.

6.Secure the adapter plate to the T-Bar using the supplied flat washer (4), lock washer (4) and nut (4). Make sure the adapter plate is level (use a bubble level) and both brackets are straight (vertical), not slanted, before tightening.

PAGE 20 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)

Image 20
Contents Model GB4000 This Manual Must Accompany the Equipment AT ALL TimesPage Page Table of Contents GB4000 Balloon LightParts Ordering Procedures Ordering parts has never been easierSafety Symbols Safety InformationSafety Messages General Safety Light Tower Safety Lamp SafetyEngine Safety Any enclosed or narrow areaFuel Safety Towing Safety Light TowerTransporting Safety  Never lift the equipment while engine is runningElectrical Safety  Never operate GB4000 in winds in excess of 40 MPH 64 km/hBattery Safety Environmental SafetySpecifications SpecificationsDimensions Closed OpenedFootcandle Plot Footcandle PlotGeneral Information Components GB4000 ComponentsPreparation SetupPower Disconnection Remove the adapter plate kit hardware from its container Lock Washer HEX NUT Lamp Mounting Balloon Power CableJunction BOX Mounting Lamp Cable Connections GB4000Inflating Balloon and Turning on Lamps LT12 only OperationRemoving Balloon Protective Cover Inflating Balloon and Turning on Lamps MLT only Deflating and Storing Balloon\ Caution MaintenanceReplacing Lamp Replacing Balloon Unzipping BalloonSymptom Possible Problem Solution Location of Maintenance PartsWiring Diagram Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts GB4000 Balloon Light 1 to 3 unitsNameplate and Decals 120V 60Hz 4000 WPart Name QTY. Remarks Decal WARNING, Burn Hazard FrenchElectrical Assy Part Name QTY Remarks PlateElectrical Assy Part Name Bracket and J-BOX Assy BOX Relay Terms and Conditions of Sale Parts Freight PolicyPage HERE’S HOW to GET Help