Multiquip GB4000 manual Junction BOX Mounting, Lamp Mounting, Balloon Power Cable

Page 22

SETUP

JUNCTION BOX MOUNTING

1.Secure the junction box (Figure 8) to the adapter plate using the supplied bolts (2), lock washer (2), and flat washer (2). Tighten mounting bolts securely.

LAMP T-BAR

ADAPTER

PLATE

BOLT

(2)

POLE

LOCK

WASHER (2)

FLAT

WASHER

(2)

JUNCTION BOX

LAMP MOUNTING

1.Place the GB4000 lamp fixture onto the lamp adapter plate pole as shown in Figure 9.

2.Insert locking pin into hole opening on pole, then insert cotter pin to lock pin in place.

BALLOON POWER CABLE

1.Connect the balloon power cable (Figure 9) to the 10- pin receptacle on the junction box.

Figure 8. Junction Box Mounting

LOCKING PIN

BALLOON FIXTURE

2 FT. (10 PIN)

 

BALLOON

COTTER PIN

POWER CABLE

 

PLATE ADAPTER

 

POLE

JUNCTION BOX

Figure 9. Balloon Power Cable Connection

PAGE 22 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)

Image 22
Contents Model GB4000 This Manual Must Accompany the Equipment AT ALL TimesPage Page Table of Contents GB4000 Balloon LightParts Ordering Procedures Ordering parts has never been easierSafety Messages Safety InformationSafety Symbols General Safety Light Tower Safety Lamp SafetyEngine Safety Any enclosed or narrow areaFuel Safety Towing Safety Light TowerTransporting Safety  Never lift the equipment while engine is runningElectrical Safety  Never operate GB4000 in winds in excess of 40 MPH 64 km/hBattery Safety Environmental SafetySpecifications SpecificationsDimensions Closed OpenedFootcandle Plot Footcandle PlotGeneral Information Components GB4000 ComponentsPower Disconnection SetupPreparation Remove the adapter plate kit hardware from its container Lock Washer HEX NUT Junction BOX Mounting Balloon Power CableLamp Mounting Lamp Cable Connections GB4000Removing Balloon Protective Cover OperationInflating Balloon and Turning on Lamps LT12 only Inflating Balloon and Turning on Lamps MLT only Deflating and Storing BalloonReplacing Lamp Maintenance\ Caution Replacing Balloon Unzipping BalloonSymptom Possible Problem Solution Location of Maintenance PartsWiring Diagram Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts GB4000 Balloon Light 1 to 3 unitsNameplate and Decals 120V 60Hz 4000 WPart Name QTY. Remarks Decal WARNING, Burn Hazard FrenchElectrical Assy Part Name QTY Remarks PlateElectrical Assy Part Name Bracket and J-BOX Assy BOX Relay Terms and Conditions of Sale Parts Freight PolicyPage HERE’S HOW to GET Help