Multiquip GB4000 manual Operation, Removing Balloon Protective Cover

Page 24

OPERATION

REMOVING BALLOON PROTECTIVE COVER

CAUTION

DO NOT use excessive force when zipping or unzipping the balloon. The possibility exists of the zipper tearing, which would make the balloon unusable.

1.Expose the balloon by unsnapping the buttons and unzipping the protective cover as shown in Figure 11.

 

UNZIP

BALLOON

SNAPS

PROTECTIVE

FULLY

COVER

 

 

EXPOSED

 

 

FOLD PROTECTIVE

COVER INTO ITSELF

Figure 11. Removing Protective Cover

2.Next, fold the protective cover into itself and zip. See Figure 11.

INFLATING BALLOON AND TURNING ON LAMPS (LT12 ONLY)

1.On LT12 series light towers, reconnect negative battery cable (black).

2.Slightly raise the light tower mast to allow clearance for the balloon to inflate.

3.Start the light tower engine as referenced in the LT12 light tower operation manual.

4.Once, the engine has started, place the main circuit breaker switch (Figure 12) on the LT12 control panel in the ON position.

LT12

LIGHT TOWER

240 VAC/30A

 

120 VAC/15A

MAIN

 

GFCI

BREAKER

 

BREAKER

MAIN

CIRCUIT

BREAKER

ON

CB1 CB2 CB3 CB4

LIGHT CONTROL/BREAKER

Figure 12. Main Breaker ON (LT12)

5.Next, turn on lamp circuit breakers.The balloon should begin to inflate and the lamps will light.

6.Secure any unused lamp cables.

7.Raise the light tower mast to the desired upright height.

PAGE 24 —GB4000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)

Image 24
Contents Model GB4000 This Manual Must Accompany the Equipment AT ALL TimesPage Page Table of Contents GB4000 Balloon LightParts Ordering Procedures Ordering parts has never been easierSafety Information Safety MessagesSafety Symbols General Safety Light Tower Safety Lamp SafetyEngine Safety Any enclosed or narrow areaFuel Safety Towing Safety Light TowerTransporting Safety  Never lift the equipment while engine is runningElectrical Safety  Never operate GB4000 in winds in excess of 40 MPH 64 km/hBattery Safety Environmental SafetySpecifications SpecificationsDimensions Closed OpenedFootcandle Plot Footcandle PlotGeneral Information Components GB4000 ComponentsSetup Power DisconnectionPreparation Remove the adapter plate kit hardware from its container Lock Washer HEX NUT Balloon Power Cable Junction BOX MountingLamp Mounting Lamp Cable Connections GB4000Operation Removing Balloon Protective CoverInflating Balloon and Turning on Lamps LT12 only Inflating Balloon and Turning on Lamps MLT only Deflating and Storing BalloonMaintenance Replacing Lamp\ Caution Replacing Balloon Unzipping BalloonSymptom Possible Problem Solution Location of Maintenance PartsWiring Diagram Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts GB4000 Balloon Light 1 to 3 unitsNameplate and Decals 120V 60Hz 4000 WPart Name QTY. Remarks Decal WARNING, Burn Hazard FrenchElectrical Assy Part Name QTY Remarks PlateElectrical Assy Part Name Bracket and J-BOX Assy BOX Relay Terms and Conditions of Sale Parts Freight PolicyPage HERE’S HOW to GET Help