Pioneer S-HTD330 manual Before you start, Disc / content format playback compatibility

Page 10

01Before you start

Remote controllers for different devices can interfere with each other. Avoid using remotes for other equipment located close to this system.

Replace the batteries when you notice a fall off in the operating range of the remote.

Disc / content format playback compatibility

General disc compatibility

This system was designed and engineered to be compatible with software bearing one or more of the following logos:

DVD-Video DVD-R DVD-RW

Audio CD Video CD

CD-R

CD-RW

Fujicolor CD

Kodak Picture CD

is a trademark of Fuji Photo Film Co. Ltd.

Other formats, including but not limited to the following, are not playable in this system:

DVD-Audio / SACD / DVD-RAM

DVD-ROM / CD-ROM*

*Except those that contain MP3, WMA or JPEG. See also Compressed audio compatibility and JPEG file compatibility below.

10

DVD-R/RW and CD-R/RW discs (Audio CDs and Video CDs) recorded using a DVD recorder, CD recorder or personal computer may not be playable on this system. This may be caused by a number of possibilities, including but not limited to: the type of disc used; the type of recording; damage, dirt or condensation on either the disc or the player’s pick-up lens. See below for notes about particular software and formats.

CD-R/RW compatibility

This system will play CD-R and CD-RW discs recorded in CD Audio or Video CD format, or as a CD-ROM containing MP3, WMA or JPEG files. However, any other content may cause the disc not to play, or create noise/distortion in the output.

This system cannot record CD-R or CD- RW discs.

Unfinalized CD-R/RW discs recorded as CD Audio can be played, but the full Table of Contents (playing time, etc.) will not be displayed.

DVD-R/RW compatibility

This unit will play DVD-R/RW discs recorded using the DVD-Video format that have been finalized using a DVD recorder.

This unit will play DVD-RW discs recorded using the Video Recording (VR) format.

DVD-RWshows in the display when a VR format DVD-RW disc is loading.

When playing a VR format DVD-RW discs that was edited on a DVD recorder, the screen may go momentarily black at edited points and/or you may see scenes from immediately before the edited point.

This system unit cannot record DVD-R/ RW discs.

Unfinalized DVD-R/RW discs cannot be played in this system.

En

Image 10
Contents XV-HTD330 Important Safety Instructions For U.S. model Important NoticeEnergy-saving design Information to UserContents Video Adjust menu Using the timerSurround sound setup Initial Settings menuPage Before you start FeaturesBefore you start Chapter Using the remote control Putting the batteries in the remote controlBefore you start What’s in the box General disc compatibility Disc / content format playback compatibilityBefore you start CD-R/RW compatibilityAbout WMA PC-created disc compatibilityCompressed audio compatibility Jpeg file compatibility Connecting up Chapter Connecting upConnecting the speakers Connecting up Placing the speakersWall-mounting the center and surround speaker system Before mountingConnecting up Connecting to your TV Connecting using the S-video outputConnecting using the component video output Listening to TV audio through this systemAssembling the loop antenna Connecting up Connecting the supplied antennasAM loop antenna Connecting the power FM wire antennaControls and displays Chapter Controls and displaysFront panel Controls and displays RPT and RPT-1 Timer indicatorsSpeaker indicators 12 2 PRO Logic IIControls and displays Remote control Tune +/-, ST +/-, cursor control buttons and Enter Playback controlsPress to display/change disc information shown on-screen Press to display the clock and to access the timer menuDisplay Shift + 8 Press to clear an entryGetting started Switching on and setting upGetting started Chapter Setting the clock Using the Room SetupGetting started Using the on-screen displays ButtonPlaying discs Press OPEN/CLOSE to open the disc tray Load a discBasic playback controls Shows Resume or Last MemResume and Last Memory Using the front panel controlsPress to start fast reverse Press Exchange to open the disc tray Getting started Changing discsPress Exchange or OPEN/CLOSE to close the disc tray DVD-Video disc menus NumbersGetting started Video CD PBC menus Listening to the radioImproving poor FM reception Listening to station presetsPress Enter to save the station preset Memorizing stationsSelect the source you want to listen to Getting started Listening to other sourcesIf necessary, start playback of the external source Home theater sound Chapter Auto listening modeHome theater sound Listening in surround soundUse the cursor up/down buttons to adjust the setting Listening with headphonesDolby Pro Logic II Music settings Home theater soundUsing the Advanced Surround effects Adjusting the Advanced Surround effect levelListening with a virtual surround back speaker Using Quiet and Midnight listening modesHome theater sound Enhancing dialogue Press Dialogue to select the amount dialog enhancementBoosting the bass level Home theater sound Adjusting the bass and trebleMuting the sound Playing audio and video discs Playing only CDs, MP3 and WMA discs CD modeUsing the Disc Navigator to browse the contents of a disc Playing audio and video discs ChapterScreen for CDs and Video CDs shows a list of tracks Playing audio and video discsNot all VR format DVD-RW discs have a Playlist F033, T035, etcPlaying in slow motion Scanning discsFrame advance/frame reverse Press Enter on ‘AStart Point’ to set the loop start point Using repeat playLooping a section of a disc Press Enter on ‘BEnd Point’ to set the loop end pointUsing random play Select a repeat play optionCreating and editing a DVD program list Select a random play optionSelect ‘Create/Edit’ from the list of program options Press Home Menu and select ‘Play Mode’Select ‘Program’ from the list of functions on the left Press Enter to add the highlighted item to the program listMake sure that a non-DVD disc is in the play position Other functions available from the program menu Press Home Menu and select Play ModeIf a tray position is empty, ‘- -’ is displayed Select a program play function Create/Edit See above Switching DVD audio languageSearching a disc Press Enter to start playbackSwitching audio channel when playing a Video CD Switching subtitlesZooming the screen Switching camera angles Displaying disc informationFront panel display information Playing a Jpeg slideshow Viewing Jpeg discsViewing Jpeg discs Chapter Press DVD Menu to display the Disc Navigator screenUse the cursor buttons Navigate Using the Photo BrowserViewing Jpeg discs Use the cursor buttons Highlight a thumbnail pictureTo resume the slideshow, press play Setting the wake-up timer Using the timerUsing the timer Chapter Set the switch-on timeTurning the wake-up timer on/off Using the timerSetting the sleep timer Buttons to select Timer on or Timer OFFTo check how much time is left, repeat steps 1 Remaining time is displayed momentarilySetting up surround sound Surround sound setupSurround sound setup Chapter System Setup menu optionsLFE attenuator setting Surround sound setupSetting the channel levels Dual mono settingWhen you’re done, press Enter to exit test tone setup Video Adjust Video Adjust menuVideo Adjust menu Chapter Creating your own presetsVideo Adjust menu Using the Initial Settings menu Initial Settings menuInitial Settings menu Chapter Video Output settingsComponent Out Initial Settings menuDefault setting Interlace About progressive scan videoAudio Language Language settingsVideo Out Subtitle LanguageSubtitle Display Display settingsDVD Menu Language OSD LanguageOptions Angle IndicatorRegistering a new password Parental LockChanging your password Setting/changing the Parental Lock levelSelect ‘Country Code’ Setting/changing the Country CodePhotoViewer Select a country codeAdditional information Using and taking care of discs Resetting the systemAdditional information Storing discs Proper installation and maintenance of this systemHints on installation Discs to avoidPower cable caution Cleaning the pickup lensProblems with condensation Moving the system unitExternal AM antenna Additional information Connecting external antennasConnecting auxiliary components External FM antennaPress Sound Mode Use the Use Reducing the TV and line signal levelsRecording mode Right buttons to select ‘Rec Mode?’ Press Enter UseAdditional information Troubleshooting GeneralDVD/CD/Video CD player STANDBY/ON buttonWMA/MP3/JPEG discs TunerError Messages Widescreen TV users Selecting languages using the language code listAdditional information Screen sizes and disc formats Standard TV usersLanguage Language code letter, Language code Additional information Language code listCountry code list Country, Country code, Country code letterAdditional information Glossary PCM Pulse Code Modulation Mpeg audioMpeg video PBC PlayBack Control Video CD onlyAdditional information Specifications Surround speakers Accessories Speaker systemSubwoofer Page Additional information Additional information Pioneer Corporation