Pioneer S-HTD330 Before you start What’s in the box, Putting the batteries in the remote control

Before you start

What’s in the box

Please confirm that the following accessories are in the main system box when you open it.

•Remote control

•AA/R6P dry cell batteries (x2)

•Video cable (yellow plugs)

•AM loop antenna

•FM wire antenna

•Power cable

•These operating instructions

•Warranty card

Please confirm that the following accessories are in the speaker box when you open it.

•Speaker cables (x6)

•non-skid pads for speakers (1 sheet)

Putting the batteries in the remote control

1Open the battery compartment cover on the back of the remote control.

2Insert two AA/R6P batteries into the battery compartment following the indications ( , ) inside the compartment.

01

3 Close the cover.

Incorrect use of batteries can result in hazards such as leakage and bursting. Please observe the following:

•Don’t mix new and old batteries together.

•Don’t use different kinds of battery together—although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that isn’t going to be used for a month or more.

•When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

H048 En

Using the remote control

Keep in mind the following when using the remote control:

•Make sure that there are no obstacles between the remote and the remote sensor on the system unit.

•The remote has a range of about 23 ft. / 7 m at an angle of less than 30º.

•Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the system unit’s remote sensor.

9

En