Pioneer S-HTD330 manual DVD/CD/Video CD player, STANDBY/ON button

12Additional information

Problem	Remedy
Can’t operate the remote	• Replace the batteries (see Putting the batteries in the remote control
control.	on page 9).
	• Operate within 23 ft. / 7 m, 30° of the remote sensor on the front
	panel (see Using the remote control on page 9).
	• Remove any obstacles or operate from another position.
	• Avoid exposing the remote sensor on the front panel to direct light.

Timer indicator is blinking and the system will not switch on.

•Unplug the system, then plug back in. Wait for one minute then switch on.

•Make sure the fan at the rear of the system unit is not being blocked.

•Check that the speakers are connected correctly.

•Make sure the voltage of the mains power source is correct for the model.

•If the problem persists, take it to your nearest Pioneer

authorized service center or your dealer for servicing.

DVD/CD/Video CD player

Problem	Remedy
The disc is ejected	• Clean the disc.
automatically after loading.	• Align the disc properly in the disc guide.
	• If the region number on a DVD-video disc does not match the
	number on the system unit, the disc cannot be used (see DVD Video
	regions on page 74).
	• Allow time for any condensation inside the system unit to evaporate.
	Avoid using the system near an air-conditioning unit.
Playback is not possible.	• If the disc is loaded upside down, reload the disc with the label side
	face up.
Picture playback stops and	• Press (stop), then (play) to start playback again.
the operation buttons	• Switch the power off once, then on again using the front panel
cannot be used.	STANDBY/ON button.
Settings are canceled.	• When the power is cut due to power failure or by unplugging the
	power cable, settings will be canceled.
No picture/No color.	• Check that connections are correct and that plugs are inserted fully.
	• Check the instruction manual of the TV/monitor to make sure the
	TV/monitor settings are incorrect.
Screen is stretched or	• The TV Screen setting is incorrect. Set the TV Screen option to
aspect does not change.	match the TV/monitor you're using (see TV Screen on page 66).

80

En