2Rotate
4
Special tool for |
| Shield | |
| Armor | ||
connecting wires, |
|
| |
fitted inside the | Conductor | Vinyl sheath | |
Distribution Box | |||
|
| ||
1 Insert | S =0.75 mm2 | Anticorrosive sheath | |
=1.11 mm |
| ||
3 |
|
| |
|
| (Sectional view) | |
Terminal Board TB1, TB3 Cross section | Fabrication of cable | ||
Power Supply Cable from Ship's Mains
If the ship's mains is AC, the power supply cable must be connected to TB5 in the Distribution Box. In case of DC ship's mains, cable must be connected to TB6 in the Distribution Box. For further information, refer to page 16.
Attaching EMI core
Attach EMI core (supplied) to the power cable to prevent noise.
13.Tape the power cable where the EMI core is to be attached, to hold the core in place.
14.Fasten the core close to the power cable connector.
Display unit
EMI core
To distribution box
16