4.Grease (supplied) both sides of the gasket 1 and the inner side of the spacer. Place the gasket 1 onto the spacer.
5.Clean the flange side of the gate valve, and place it on the gasket 1. The scale side of the gate valve should be up.
6.Fix stud bolts with washers and bolts loosely.
7.Keep seachest cap and shaft assembly free of dirt and dust.
8.Grease
9.Place the assembly made at step 8 on the gate valve.
10.Fix the assembly with bolts, nuts and washers loosely.
11.Unscrew nuts from flange 2, and confirm that shaft can be moved up and down smoothly by hand.
You will feel some resistance because of the
Nut
Washer
Flange 2
12. Fasten the gate valve with bolts, nuts and washers above and below.
NOTE) When installing a transducer, do it before step 7 or after removing the seachest cap and the shaft assembly.
10