Furuno GP-1850D Installation of Antenna Unit, Flush mounting of display unit

6-R2.25

Pan head screws

0.5	0.5
147	89

Flush mount

242 0.5

4.5 244 1

50

15 0.5

238 1

(Cutout for flush mount)

143 1

Figure 1-3 Flush mounting of display unit

1.2 Installation of Antenna Unit

Mounting considerations

Install the antenna unit referring to the installation diagram on page D-3 or D-4. When selecting a mounting location for the antenna unit, keep in mind the follow- ing points:

•Select a location out of the radar beam. The radar beam will obstruct or prevent reception of the GPS satellite signal.

•The location should be well away from a VHF antenna. A GPS receiver is inter- fered by a harmonic wave of a VHF antenna.

•There should be no interfering object within the line-of-sight to the satellites. Objects within line-of-sight to a satellite, for example, a mast, may block recep- tion or prolong acquisition time.

•Mount the antenna unit as high as possible. Mounting the antenna unit as high as possible keeps it free of interfering objects and water spray, which can inter- rupt reception of GPS satellite signal if the water freezes.

•The length of the whip antenna for the GP-1850D should be no longer than 1.2 meter to prevent antenna damage. Do not use a 2.5 meter whip antenna.

•If the antenna cable is to be passed through a hole which is not large enough to pass the connector, you may unfasten the connector with a needle nose pliers and 3/8-inch open-end wrench. Refasten it as shown in Figure 1-4 after run- ning the cable through the hole.

Washer Gasket (reddish brown)

Shield

Clamp nut

Center pin (soldered)

Connector shell

Figure 1-4 How to assemble the connector

1-3