Installation of DGPS receiver
Procedure
1.Dismount chassis assembly from panel/chassis assembly by disconnecting the connector and PH8P from J8 on MAIN Board shown in the figure below.
Remove two ties
Chassis Assembly
PH8P
Connector
Panel Assembly
Figure 4-2 Dismounting chassis assembly
2.Dismount heat sink from chassis assembly by unfastening three screws on the ANLG board, loosening a screw at TR fixing plate and disconnecting the con- nector of the mini pin coax cable.
ANLG Board | Screws (3 X 8), 3pcs. |
|
Mini pin coax cable
Heat Sink
TR fixing plate