Operating this unit Bluetooth Telephone

	Section
Operating this unit	02

Bluetooth Telephone

Important

!Since this unit is on standby to connect with your cellular phone via Bluetooth wireless technology, using this unit without running the engine can result in battery drainage.

!Advanced operations that require your atten- tion such as dialing numbers on the monitor, using phone book, etc., are prohibited while you are driving. When you need to use these advanced operations, stop your vehicle in a safe place.

Setting up for hands-free phoning

Before you can use the hands-free phoning function you must set up the unit for use with your cellular phone. This entails establishing a Bluetooth wireless connection between this unit and your phone, pairing your phone with this unit, and adjusting the volume level.

1 Connection

For detailed instructions on connecting your phone to this unit via Bluetooth wireless tech- nology, refer to Connecting and disconnecting a cellular phone on the next page.

2 Pairing

Pairing is usually performed automatically during the connection operation. You only need to perform this operation manually when your phone is connected temporarily for any reason.

We recommend you pair the phone to this unit to make best use of the technology.

To pair your temporarily connected phone, refer to Pairing a connected cellular phone on page 26.

3 Volume adjustment

Adjust the earpiece volume on your cellular phone for comfort. When adjusted, the volume level is recorded in this unit as the default set- ting.

#Caller’s voice volume and ring volume may vary depending on the type of cellular phone.

#If the difference between the ring volume and caller’s voice volume is big, overall volume level may become unstable.

#Before disconnecting the cellular phone from this unit, make sure to adjust the volume to a proper level. If the volume is muted (zero level) on your cellular phone, the volume level of your cel- lular phone remains muted even after the cellular phone is disconnected.

Notes

!The equalizer curve for the phone source is fixed.

!When selecting the phone source, you can only operate FADER (balance adjustment) in the audio menu.

!When selecting the phone source, the fader value is set to FADER :F15 as an initial setting.

Introduction of connection and registration

1Press MULTI-CONTROL to display the main menu.

2Use MULTI-CONTROL to select

CONNECTION.

The connection menu is displayed.

Turn to change the menu option. Press to se-

lect.

# You can also select this menu by pressing and holding PHONE//CONNECT on the ordinary display.

3Turn MULTI-CONTROL to select the function.

PAIRED PHONE (paired phone)—

BT HANDS FREE (new phone)—SET PHONE (phone registration)—DISCONNECT PHONE (disconnect phone)—DELETE PHONE (delete phone)

If the phone is not connected and not paired

The following function can be operated.

!BT HANDS FREE (new phone)

If the phone is not connected but paired The following functions can be operated.

!PAIRED PHONE (pair phone manually)

Operating this unit

En 23