Fusion MS-IP700 Channel Skipping, Sub filter, To set or unset a channel from being skipped

Tuning	Applies	When tuning with this method…
Method	to…
Manual	All bands	• Press the Forward or Backward key to step through
		the range of frequencies or channels one at a time.
		• Press and hold down the key for rapid scanning of
		frequencies or channels.
Manual	SiriusXM	• Press the Forward or Backward key to step through
		all channels one at a time.
Category	SiriusXM	• Press the Play / Pause, Forward or Backward key to
		step through the channels in the selected category.
		• Only available when a category is selected in the
		Category menu item. For further details see
		“Category” on page 51.
Auto	AM/FM	• Press the Forward or Backward key to start
		searching for available stations.
		• Press the Play / Pause, Forward or Backward key to
		stop the search.
Scan	VHF	• Scans through preset channels, pausing on a
		channel while it is transmitting.
		• Only available if there are two or more presets
		saved.
		• If there is any background noise, the scan will stop.
		For further details see “Minimizing background
		noise” on page 19.
		• Press the Play / Pause, Forward or Backward key to
		turn scan mode off. For further details see “Turning
		scan mode on” on page 19.
		NOTE: The Scan function is activated from the
		settings menu, see ‘Setting up VHF’
Preset	All bands	• Press the Forward or Backward key to step through
		available presets.
		• Only available if there are two or more presets
		saved.
		• To tune to a specific preset:
		a. Press the Menu key, and then press the
		Encoder to select Presets.
		b. Turn the Encoder to highlight the required
		preset.
		c. Press the Encoder to tune to the highlighted
		preset.
		For further details, see “Adding and Removing Presets”
		on page 18.

2.(if required) turn and then press the Encoder to select Parental > Unlock. Enter your access code.

3.Select the Lock/Unlock menu item.

4.Turn the Encoder to highlight a channel then press the Encoder to

lock ( ) or unlock ( ) the channel, as required.

5.Press the Menu key (or leave to time out) to exit.

Channel Skipping

Channel skipping gives the user the ability to set a channel to be skipped / missed while navigating via the Forward and Back key in the Sirius Source Screen. The user still able to navigate to a skipped channel via the channel list found in the menu.

To set or unset a channel from being skipped:

1.Press the Menu key.

2.(if required) turn and then press the Encoder to select Parental > Unlock. Enter your access code.

3.Select the Skip/UnSkip menu item.

4.Turn the Encoder to highlight a channel then press the Encoder to turn on

( ) or turn off ( ) skip, as required.

5.Press the Menu key (or leave to time out) to exit.

ADVANCED SETTINGS

The settings described in this section are usually set up when the unit is installed and not changed again.

Menu key	Rotary
	Encoder

Sub filter

Use the sub filter setting to control the sub-woofer cutoff frequency. Audio signals above the selected frequency will not be passed on to the sub-woofer. The sub filter settings apply to all sub-woofer outputs.

17 54