Fusion Installation Guide for IP700i and MS-AV700 Car Video Systems

INSTALLING THE 700 SERIES

Dimensions are in millimeters (mm) and inches (”). Not to scale.

Figure 7 – Dimensions - top view

INSTALLATION

IF ANY MODIFICATION TO THE VESSEL IS REQUIRED, SUCH AS DRILLING HOLES ETC, FUSION RECOMMENDS CONSULTATION WITH YOUR BOAT DEALER OR MANUFACTURER BEFOREHAND.

>>Fit mounting gasket

>>Insert the unit into the mounting hole

>>Pull down the front face to expose the mounting screw locations

>>Use either the supplied 4 x wood screws, or 4 x machined screws and metal clamps to affix the unit into position.

>>The unit must be mounted within 30 degrees of the horizontal plane.

Note: In some circumstances a back strap or brace may be required at the rear of the unit (Back Strap / Brace is not included).

Appropriate mounting is very important to ensure correct operation. Select a location that allows both free/open airflow around the rear of the chassis, whilst minimizing exposure to moisture. Allow adequate room at the rear of the unit for the cable looms (approx 2 - 3”).

Recommended Clearance 205 (8-3/32”)

	217.0	(8-9/16”)
	195.0	(7-11/16”)						(3/32”)
	181.0	(7-1/8”)		2	.0
			R
79.0 (3-1/8”)	53.0 (2-3/32”)							58.0 (2-9/32”)
					4	.	0	(5/32”)
16.5 (5/8”)

DOOR OPENING CLEARANCE PRODUCT OUTLINE CUTOUT

ELECTRICAL WIRING

Caution: The MS-IP700 and MS-AV700 are designed for vessels with a 12V DC Negative ground electrical system.

33 38