Yamaha Yamaha Mixing Consol, M2500 owner manual Matrix switch

Control panel

■GROUP/AUX FLIP switch= AUX ()

The signals of AUX buses 7–14 will be sent to chan- nels G1/A7–G8/A14 respectively, and will be output individually from the GRP/AUX OUT G1/A7–G8/ A14 jacks.

	PAN		PAN
	C		C
	L	R	L	R
	MATRIX	ST	MATRIX	ST
		MONO		MONO
		LCR		LCR
		CHECK		CHECK
		ON		ON
	ON/EDIT		ON/EDIT
	10		10
	5		5
	0		0
	5		5
	10		10
	20		20
	30		30
	40		40
	50		50
	60		60
0	10	AFL		AFL
	AUX6
	G1 / A7		G2 / A8

010

AUX7

010

AUX8

PRE

010

AUX9

010

AUX10

D PAN control

This adjusts the pan of the signal that is sent from the G1/A7–G8/A14 section to the STEREO or MONO/C bus. The function of the PAN control will change as follows, depending on the setting of the channel assign switch (5).

●When the ST switch is on

PAN will adjust the pan of the signal that is sent from each channel to the STEREO L/R bus.

●When the LCR switch is on

PAN will adjust the pan of the signal that is sent from each channel to the STEREO L/R bus and MONO/C bus.

E Channel assign switches

These switches assign the post-fader post-PAN signal to the desired bus.

•ST (stereo) switch

If this switch is on (), the post-PAN signal of the output channel will be sent to the STEREO bus.

•MONO (monaural) switch

If this switch is on (), the signal of the output channel will be sent to the MONO/C bus.

•LCR switch

If this switch is on, the indicator above the switch will light, and the post-PAN signal of the output channel will be sent to the STEREO bus and the MONO/C bus.

•MATRIX switch

IF this switch is on (), the signal of the output channel will be sent to the corresponding MATRIX bus.

Note:

•The LCR switch takes priority over the ST/ MONO switch. If the LCR switch is on, the post-PAN signal of the G1/A7–G8/A14 section will be sent to the STEREO bus (L/R) and MONO/C bus regardless of the on/off status of the ST/MONO switch. (Refer to response curve diagram 1 on page 4.)

•If the LCR switch is off, the ST/MONO switch will function as a conventional channel assign switch. If ST is on, the post-PAN signal of the G1/A7–G8/A14 section will be sent to the ST bus. If the MONO switch is on, the signal of the G1/A7–G8/A14 section will be sent directly to the MONO/C bus. (Refer to response curve diagram 2 on page 4.)

12 M2500—Owner’s Manual