Fujitsu MB96300 manual Synchronous Mode, Flash Programming Socket

Page 31

SK-96370-144PMC-GDC User Guide

Chapter 5 Programming the internal Flash memory

4)After programming the Flash-device, switch off the power supply and set back the mode according to the usage of the application, e.g.:

DIP-Switch S1

(RUN Mode)

MD0 MD1 MD2 nc

ON

OFF

1 2 3 4

5)Power on the board. The user application is started directly.

5.2Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.

A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct connection to this programmer.

X4: Flash programming socket

n/c 1 MD0 3 RST 5

SOT3 7

VCC 9

2n/c

4n/c

6SIN3

8SCK3

10GND

Figure 5-1: Flash Programming Socket

© Fujitsu Microelectronics Europe GmbH

- 31 -

FMEMCU-UG-960014-10

Image 31
Contents MB96300 Series Revision History Date IssueNo Liability for Consequential Damages Warranty and DisclaimerContents Programming the Internal Flash Memory Abstract OverviewFeatures General Description Emulator System 8 I2C BusEmulation System Connection/Power-On InstallationDo not use any other probe cable than MB2198-507-E only Jumper Description / Function Type Default Coordinates Default Jumper settings for MB96370 SeriesFlash / Lime Jumper SettingsJumper Location Default Jumper SettingsOperating Mode S1 Jumpers and SwitchesMCU Operating Mode Mcuvcc Power Supply S2, JP 8, 15, 16, 17Power Supply Configuration JP8JP2 Subclock JP 1JP1 JP2ADC Supply Analog Power Supply Voltage JP 11, 12, 13Alarm Comparator JP Alarm ComparatorRST MCU Reset Generation JP 33, 41, 46, 47Uart Reset Reset ConnectionI2C pull-up resistor JP 9 User Buttons SW1, SW2, SW3, SW4, SW5, SW6 JP 3, 4, 5, 6User Push Buttons LIN / Uart UART0 SettingsLIN-UART 0 JP 19, 21, 23, 25, 27, 28, 29 Can interfaces JP 24, 26, 34 UART2 SettingsCan Settings LIN-UART 2 JP 36, 37, 38, 39, 40, 42, 43External Sram memory JP 50, 53 10 External Flash Configuration11 Flash Configuration Jumpers External Flash memory JP 49, 52Flrst Glrst12 Graphic Display Controller interface LIN-UART connectors X5 ConnectorsPower connector MCU pin header connectors X20A, X20B, X21, X22Canh Can Connector X6Can Connector Signals CanlUser LEDs/LCD USER-LEDs & optional LC-Display J1SIN3 In-Circuit-Programming ConnectorMD0 RstxExternal Supply Voltage Vin J3 Alarm Comparator Connector J2VCC Connector J7 GND Connector J8Programming the internal Flash memory Asynchronous ModeJumper Settings for Programming via Uart 0 Jumper Settings for Programming via Uart 2Jumper Settings for reset signal Reset optionalFlash Programming Flash Programming Socket Synchronous ModeRelated Products AppendixHttp//mcu.emea.fujitsu.com Information in the WWWEvaluation Board Emulation Board China-RoHS regulationTable of hazardous substances name and concentration Gültig für EU-Länder RecyclingValid for European Union Countries