Fujitsu MB96300 manual Reset optional, Flash Programming, Jumper Settings for reset signal

SK-96370-144PMC-GDC User Guide

Chapter 5 Programming the internal Flash memory

5.1.3Reset (optional)

Depending on the programming software a reset signal might be generated by RTS or DTR line. In order to use this optional feature additional jumper have to be set:

	Jumper	Programming	Setting	Description
		UART
	JP23	UART0	1-2	DTR signal of X5 is used as reset source
	(DTR/RTS)		2-3	RTS signal of X5 is used as reset source
	JP38	UART2	1-2	DTR signal of X9 is used as reset source
	(DTR/RTS)		2-3	RTS signal of X9 is used as reset source
	JP33	UART0 or	1-2	LIN-UART 0 (X5) is used to generate reset
	(RESET A/B)	UART2	2-3	LIN-UART 2 (X9) is used to generate reset
	JP41	UART0 or	1-2	No negation for the DTR/RTS signal
(DTR / DTRx)		UART2	2-3	DTR/RTS signal is negated

Table 5-3: Jumper Settings for reset signal

5.1.4Flash Programming

1)Configure the microcontroller mode:

MD0 MD1 MD2 nc

DIP-Switch S1

(Programming Mode)

ON

OFF

1 2 3 4

2)Connect the configured UART (see above) to your serial PC communication port. A straight 1:1 cable connection has to be used.

3)Start the tool “Fujitsu Flash MCU Programmer” software and make the settings:

	Set Device Type		Select COM Port
Select Crystal
		MB96F379R/Y
		4 MHz
Open Source
		Application.MHX

(MHX-File) Start programming

FMEMCU-UG-960014-10 - 30 - © Fujitsu Microelectronics Europe GmbH