Tascam Power jack and switch, FW-1082 outputs produce a thump when the power is turned on

Page 15

2 – Parts of the FW-1082

POWER jack and switch

Connect only the power adapter supplied with your FW-1082 to this jack.

Make sure the switch is off when making the power connection.

WARNING

The FW-1082 outputs produce a “thump” when the power is turned on.

To avoid any damage to hearing or equipment, turn the volume of the monitoring system down, or make sure it is turned off, and do not wear headphones connected to the FW-1082 when powering the unit up or down.

TASCAM FW-1082 Owner’s Manual 15

Image 15

Contents DAW Control Surface / FireWire Audio-MIDI Interface For Canada Important Safety PrecautionsImportant Safety Instructions Contents Troubleshooting and Support SpecificationsControl Panel Table of Figures 1IEEE.1394 4-pin and 6-pin connectorsFeatures IntroductionOverview System Requirements BoxNomenclature used in the manual Software application notes Special notes for touch-sensitive fadersCopyright, etc Front Panel Parts of the FW-1082Channel controls Monitoring and indicators Mode controlsEncoders and controls Monitoring Phones Line inputs and inserts Power jack Rear panelDAW transport controls Monitoring and phones Mic inputs and phantom power switchFoot switch jack Foot SW Coaxial Digital audio I/O in and OUTFW-1082 outputs produce a thump when the power is turned on Power jack and switchDedicated Computer Controls Functional OverviewControl Surface Modes Global ControlsDedicated Modifier Keys Setting and checking clock ratesComputer Control Mode General Notes Control Surface Modes and OperationNative Protocol HUI Emulation Protocol Mackie Emulation ProtocolCursor keys Midi Control Mode General NotesSetting the Midi message type Programming the Midi Control MessagesProgramming Keys Controller On/Off Programming EncodersMonitor Mix Mode General Notes Programming FadersBanking Audio I/O and the Monitor Mixer Monitoring SetupsMaking mixer settings Setting the master fader to 0dB unity gainSetting Input levels Settings tab Control PanelMaster Fader Affects Anlg LR Gain Quick Start tab Windows only Midi Programming tabCore Audio tab for OS CoreAudio tab OS X onlyTroubleshooting and Support Audio troubleshootingControl surface troubleshooting Contacting Us Analog I/O SpecificationsOverall System Specifications Digital I/OMisc. I/O Analog performance Physical, etc. specificationsDimensions of the FW-1082 Dimensional drawingPage FW-1082