Roland FP-5 owner manual Before You Play, Making Connections, Installing the Music Stand

Before You Play

Making Connections

1. Before you begin making connections, confirm the following.

Is the volume level of the FP-5 turned all the way down?

Is the power to the FP-5 turned off?

2. Connect the supplied AC cable to the supplied AC adaptor.

fig.00-01

AC adaptor AC cable Power outlet

3. Connect the supplied AC adaptor to the FP-5, and then plug its other end into a power outlet.

To prevent the inadvertent disruption of power to your unit (should the plug be pulled out accidentally), and to avoid applying undue stress to the AC adaptor jack, anchor the power cord using the cord hook, as shown in the illustration.

fig.00-02

Rear Panel

Installing the Music Stand

fig.00-03

1.	Using the supplied screws, attach the music stand to the
	back of the FP-5 as illustrated.
	Be sure to use the supplied screws for attaching the music stand.
	Turn the screws clockwise until they’re held in place–but don’t tighten them
	yet.
2.	Put the music stand between the screws and the FP-5’s body.
3.	While supporting the music stand with one hand, secure it in
	place by turning the screws.
	* When attaching the music stand, support it firmly with one hand to make sure that	NOTE
	you don’t drop it. Be careful, so you don’t get your fingers pinched.	Do not apply excessive
4.
	To remove the music stand, support it with one hand while	force to the installed music
		stand.
	loosening the screws.
	* After removing the music stand, don’t forget to retighten the screws.

8