Pioneer Official Manual for Stereo Receivers: VSX-D710S and D810S Models

Preparations

Optical digital input 4 setting (VSX- D850S only)

Here you tell the receiver what component you have hooked up to the optical input jack 4.

Press % or fi to select the optical digital input 2 (DVD, TV, CD, CD-R, VCR, or OFF).

After you assign a component to this digital jack whenever you select that component, for example a CD player, the receiver will automatically change to the digital input setting. You can see this in the DIGITAL/ANALOG indicator on the front of the receiver.

MEMO:

•The initial setting is “VCR”.

•The digital out signal corresponds to the selected input function (for example, DVD).

Setting the Volume Level of Each Channel (adjusting the speaker volume balance)

3Press TEST TONE to output the test tone.

The test tone is output in the following order.

VSX-D710S

FL CT FR

SW SL SR

VSX-D810S/D850S

FL CT FR SR

SW SL SB

•Test tone is only output in Dolby/DTS modes. The test tone sequence corresponds to the speaker setting mode.

4Adjust speaker levels so that you hear the test tone at the same volume from each speaker when seated in the main listening position.

•If a speaker is deselected in the speaker setting mode (see p. 17) then no test tone will be output for that speaker.

•The channel level range is ± 10 dB.

•Levels can be set for each surround mode.

5 Press TEST TONE to turn off the test tone.

Use to set the relative volume of each channel.		MEMO:
		• Since the SUBWOOFER transmits an ultra-low
		frequency its sound may seem quieter than it actually
SOURCE	RECEIVER	is.

	DVD		TV	VCR	CD-R		• The speaker volume can be adjusted without
	RCV		CD	TUN	TVC		outputting the test tone by pressing CH LEVEL or
			MULTI CONTROL
	1		2		3		CH SELECT button.
	MIDNIGHT		5.1 / 7.1		ATT		• Initial setting is 0 dB.
	4		5	EFFECT	6
	7		8		9		• You can set each sound mode individually and these
	10		0		DISC
					ENTER		settings are completely independent of each other.
	¶		7	3	8
	DTV INFO	MPX/RETURN		D.ACCESS	GUIDE		The sound modes you can set include DSP, stereo,
1	1		¡	4	¢
	BAND		CLASS	DTV ON/OFF DTV MENU		3,5
	CH SELECT		CH LEVEL		FUNCTION		DVD 7.1 Ch and 2/DTS, as explained in steps
	2/DTS		DSP	TEST TONE	SIGNAL SELECT
CH SELECT	LOUDNESS	FL DIMMER		SETUP	MUTING		above. However, you can only use the test tone
4			TUNE				feature when setting 2/DTS.
	ST				ST
			ENTER

TUNE

CHANNEL
VOLUME	MASTER VOLUME
MENU	2
TVFUNC
TV
TV CONTROL

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

1Press 2/DTS.

2Press MASTER VOLUME + or – to adjust the volume to an appropriate level.

21

En