Controlling the Rest of Your System

Recalling Preset Codes

The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset code is assigned, pressing the button will automatically set the remote to operate the respective component.

MEMO:

•Refer to “Preset Code List” on pages 43 to 49 for the components and manufacturers available.

•Refer to “Controlling the Rest of Your System” on pages 35 to 49 for detailed explanations on how to operate your other components.

SOURCE		RECEIVER		LED
				LED
DVD	TV	VCR	CD-R	2
	MULTI CONTROL			2
RCV	CD	TUN	TVC
1	2		3	3
MIDNIGHT	5.1 / 7.1		ATT
4	5		6
		EFFECT
7	8		9
10			DISC
	0		ENTER
DTV INFO MPX/RETURN		D.ACCESS	GUIDE
¶	7	3	8
BAND	CLASS	DTV ON/OFF DTV MENU
1	¡	4	¢
2/DTS	DSP	TEST TONE	SIGNAL SELECT
CH SELECT	CH LEVEL		FUNCTION

LOUDNESS

FL DIMMER

SETUP

MUTING

TUNE

ST	ST
	ENTER
	TUNE
	CHANNEL
VOLUME	MASTER VOLUME
	MENU

TVFUNC

TV CONTROL

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

3Use the number buttons to enter the 4 digit setup code. (see pages 43-49 for Preset Code List)

The LED will blink for half a second after each digit is input and will show a long, two second blink to confirm a valid code has been input. (VSX-D850S only: The code appears in the LCD display as you input it. The display shows OK if it’s a valid code.)

If the LED blinks three times it means an invalid code has been input or an error has occurred. Check the preset code list and try again. If you are not able to input a preset code you can refer to page 38 to teach the remote control individual commands.

The remote control returns to the previous operation mode. It will also return to the previous mode after thirty seconds of inactivity.

4Repeat steps 1 through 3 to assign preset codes for as many components as necessary.

MEMO:

•You can only input a code for the component type written on each MULTI CONTROL button.

•If you recall a preset code for the tuner (TUN MULTI CONTROL), you will not be able to control the built- in tuner of this receiver using the remote. To reset the remote to the built-in tuner, input the preset code 7008.

•To erase the preset code for the current MULTI CONTROL button, enter 0000 as the code in step 3.

1Press SETUP and hold for three seconds to select the Preset mode.

The LED lights steadily for two seconds. (VSX- D850S only: The LCD display shows SETUP.)

To cancel the preset mode at any time Press SETUP.

The remote control will also return to the previous mode after thirty seconds of inactivity.

2Press the MULTI CONTROL button for the component you want to control.

Each button can be set to control one of the following components

DVD	DVD/LD player or DVD Recorder
TV	TV, Satellite tuner or Cable TV tuner
VCR	VCR or Digital Video Recorder
CD	CD player
CD-R	CD Recorder, Tape deck
	or MD player
TVC	TV or Cable TV tuner
TUN	FM/ AM tuner