Pioneer XW-HT1 Additional information, Taking care of the unit, Cleaning the unit’s exterior

Page 23

Additional information

Symptom

Cause & Remedy

The POWER indicator

• It is likely that the system is malfunctioning. Ask your nearest Pioneer

goes out when the

authorized service center or your dealer to carry out repair work.

switch is on or the

 

system is in operation.

 

 

 

Caution

Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplugging the power cord and then re-plugging it in will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest Pioneer service center.

05

English

Taking care of the unit

Cleaning the unit’s exterior

Use a polishing cloth or dry cloth to wipe off dust and dirt. If the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser diluted five or six times with water and wrung out well, then wipe again with a dry cloth.

Do not use furniture wax or cleaners. Never use thinners, benzine or insecticide sprays or other chemicals on or near this unit since they will corrode the surfaces.

If you use a chemical-impregnated cleaning cloth, read the instructions carefully before use. These cloths may leave smear marks on half-mirror finish surfaces; if this happens, finish with a dry cloth.

Unplug the unit when cleaning.

Problems with condensation

Condensation may form inside the unit if it is brought into a warm room from outside, or if the temperature of the room rises quickly.

Although the condensation won’t damage the unit, it may temporarily impair its performance. For this reason you should leave it to adjust to the warmer temperature for about an hour before switching on and using.

Hints on installation

We want you to enjoy using this unit for years to come, so please bear in mind the following points when choosing a suitable location for it:

Do...

Use in a well-ventilated room.

Place on a solid, flat, level surface, such as a table, shelf or stereo rack.

Be sure to switch the wireless speaker off when not in use.

Don’t...

Use in a place exposed to high temperatures or humidity, including near radiators and other heat-generating appliances.

Place on a window sill or other place where the unit will be exposed to direct sunlight.

Use in an excessively dusty or damp environment.

Place directly on top of an amplifier, or other component in your stereo system that becomes hot in use.

Use near a television or monitor as you may experience interference—especially if the television uses an indoor antenna.

Use in a kitchen or other room where the unit may be exposed to smoke or steam.

23

En

Image 23
Contents XW-HT1 Wash hands after handling Important Safety Instructions Information to User For Canadian model Power cord cautionFor safety in operation For U.S. modelTo establish a safe level We Want You Listening For a LifetimeContents Before you start Chapter FeaturesBefore you start Push the battery casing back into place Before you start Using the remote controlInserting the battery Transmitter Controls and displaysControls and displays Chapter DVD input CS II CINEMA, CS II Music Controls and displaysCH 1 CH 2 CH 3 CH Power indicator Controls and displays Wireless speakerTuned indicator Surround Mode buttons Controls and displays Remote controlConnecting a DVD player Connecting upConnecting up Chapter Connecting up Transmitter Connecting up Connecting a TV or mini component systemConnecting up Listening in surround sound Chapter Using the surround modesSetting an appropriate volume for the wireless speaker Listening in surround soundTV input surround modes Using the Wireless Stereo modeUsing the Wireless Off mode Listening in surround soundCinema Stereo DVD Using the front panel controlsEnglish Additional information Chapter TroubleshootingAdditional information Additional information Cleaning the unit’s exteriorProblems with condensation Hints on installationRadio wave caution Moving the wireless speakerAC adapter and power cord caution Radio wave reflectionsScope of operation SpecificationsPar mesure de sécurité Précautions concernant le cordon d’alimentationVérification des accessoires fournis Technique SRS Circle Surround II sous licence SRS Labs Avant de commencerAvant de commencer Chapitre ParticularitésMise en place de la pile Avant de commencer Utilisation du boîtier de télécommandeÉmetteur Commandes et afficheursCommandes et afficheurs Chapitre Commandes et afficheurs Témoin Tuned Commandes et afficheurs Enceinte sans filTémoin Power Wireless OFF Mute Commandes et afficheurs Boîtier de télécommandeRaccordement à un lecteur de DVD RaccordementsRaccordements Chapitre Raccordements Câble audio Caisson Monophonique De graves Raccordements Utilisation des modes d’ambiance Mettez en service l’enceinte sans filSélectionnez le mode d’ambiance W.STEREO 04 Écoute des sonorités d’ambiance ChapitreModes d’ambiance pour l’entrée TV Écoute des sonorités d’ambianceModes d’ambiance pour l’entrée 04 Écoute des sonorités d’ambiance Utilisation du mode Wireless StereoUtilisation du mode Wireless Off Utilisation des commandes de la face avantDisposition de l’enceinte sans fil Guide de dépannage Informations complémentairesInformations complémentaires Chapitre Problèmes liés à la condensation Informations complémentairesSoin de l’appareil Nettoyage de l’extérieur de l’appareilCe que vous ne devez pas faire… Conseils d’installationAvant de déplacer l’enceinte sans fil Ce que vous devez faire…’appareil Informations complémentaires Réflexions des ondesRadioélectriques Domaine d’utilisation deÉmetteur AccessoiresCaractéristiques techniques GénéralitésPioneer Corporation