Installation, PAL/NTSC Switch | Pioneer VSX-D3S guide

INSTALLATION

SETTING THE SWITCHES FOR THE MULTI-VOLTAGE MODEL ONLY

TWO VOLTAGE SELECTOR SWITCHES

(Not available on U.S. and Canadian models)

CHANNEL STEP/FM DE-EMPHASIS SWITCH (Not available on U.S. and Canadian models)

Only multi-voltage models are provided with these switches. U.S. and Canadian models are not provided with these switches. Mains voltages in Saudi Arabia are 127 V and 220 V only. Never use this model with the 110 V setting in Saudi Arabia.

The line voltage selector switches are on the rear panel. Before your model is shipped from the factory, these switches are set to the power requirements of the destination. Check that they are set properly before plugging the power cord into the household wall socket. If the voltage is not properly set or if you move to an area where the voltage requirements differ, adjust the selector switches as follows.

1.Use a medium-size screwdriver.

2.First, insert the screwdriver in the groove of the voltage selector at the right, and adjust so that the tip of the groove points to the voltage value of your area.

3.Next, insert the screwdriver in the groove of the voltage selector at the left and adjust until the voltage is the same as at the right.

TWO VOLTAGE SELECTORS

110V

120～127V

220V	220V	240V
240V	110V	120-127V
	110V	120-127V

Medium-size screwdriver

PAL/NTSC SWITCH

(Not available on U.S. and Canadian models)

This unit uses the TV screen to operate the system. Set the rear panel PAL/NTSC switch to match your TV’s color system. The screen will be unclear if the color system does not match.

The unit has been factory preset to the channel allocation and de-emphasis value for the area in which it is to be sold. If these values are set incorrectly, the tuned in frequency may be wrong, or sound may be distorted, resulting in an inability to reproduce reception signals at their proper sound quality. For this reason, be sure to confirm that the values are set correctly before first using the unit.

(FM 100 kHz/75 ∝s, AM 10 kHz) position:

Set to this position for areas with an FM reception step of 100 kHz, de-emphasis 75 ∝s and AM 10 kHz.

(FM 50 kHz/50 ∝s, AM 9 kHz) position:

Set to this position, for areas with an FM reception step of 50 kHz, de-emphasis 50 ∝s and AM 9 kHz.

NOTE:

When unsure about the channel allocation and de-emphasis values for your area, consult your dealer for correct information.

FM 50kHz	100kHz
/50μS	/75μS
AM 9kHz	10kHz
CHANNEL	STEP
/FM DE-	EMPHASIS

PAL

NTSC