Telex USR-100 operating instructions Front Panel

Page 10

Figure 1

Front Panel

Power Switch: When turned on, the channel display illuminates and one of the diversity lights will come on.

Channel Select Buttons: Push once to increase display by one. Push and hold to increase display more than one. Left button changes “10’s”, Right button changes “1’s”.

Channel Lockout: To enable/disable Channel Lockout function, press both channel select buttons simultaneously and hold them in until the channel readout stops blinking. When the buttons are released, the lockout mode will be the opposite of before. To check status of lockout, press one channel button. If the display changes, the lockout is disabled. If the display blinks rapidly, the lockout is activated.

Diversity Display: LED’s indicate diversity operation.

AF Display: A 5-segment three-color LED Display indicates the relative modulation of the system.

RF Display: A 5-segment three color LED Display indicates the relative signal strength from the transmitter.

-7-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Telex Table of Contents Table of Contents General Information Antennas Posi Phase DiversityComputer Controlled Channels Audio Output PowerDisplays AudioUSR-100 Receiver Specifications Model SH-100 Transmitter Specifications Model LT-100 Transmitter Specifications Front Panel Rear Panel Receiver Set-up Antenna MountingBottom View SH-100 Battery Meter Set-UpMicrophone Connector wired as follows Top View Side View Back View LT-100Set-Up Antenna Placement System Set-UpBracket Mounting Antenna Placement with Accessory Brackets and Cables Antenna ConnectionInstalling Rack Mounts Assembly of Rack MountDouble Mounting Model CLA-X 1/2 Wave Antenna Model AB-2 Combination Antenna BracketModel ALP-450 450-900 MHz Directional Log Periodic Antenna Front Connector Mounting KitOrder No FCC Information Customer Service Information June
Top Page Image Contents