Installing Rack Mounts, Assembly of Rack Mount

Installing Rack Mounts

The USR-100 is supplied with rack mounts for both double and single mounting in a 19" equipment rack. For single mounting, the long and short rack “ears” are used. For dual mounting, use the short “ears and the mid brackets from two USR-100’s.

Item

No.Description

1 Rack Ear, short

2 Mid Bracket

3 Rack Ear, long

4 Screw, #6-32 x 3/8" Phillips, pan head

5Screw, #6-32 x 3/16" Phillips, flat head

6Screw, #10-32 x 3/8" Phillips, pan head

Figure 8

Assembly of Rack Mount

Assembly

To assemble the rack mount to the unit(s) and install it into a 19" rack, proceed as follows:

Remove the front Phillips head screws from each side of each unit. Refer to Figure 1.

Align the rack ear (Item No. 1 or 3) with the holes on the side of the unit. Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining hole. Repeat this step for the opposite side of the unit. Tighten all screws securely.

-17-