Telex USR-100 operating instructions Rear Panel

Page 11

Figure 2

Rear Panel

Antenna Jacks: Two antenna jacks for posi phase diversity recep- tion. Attach an antenna to each jack.

Audio Output: XLR type jack connects to audio sound system (Amplifier/Mixer). Pin 1 ground, Pin 2 +, Pin 3 -.

Audio Adjust: Screwdriver adjustable potentiometer, controls audio output. Use supplied screwdriver to adjust to desired level.

Audio Level: Set switch to match the input characteristics of your audio sound system.

Power Jack: For external AC wall supply adapter (supplied). Will accept 12-15 volts AC/DC at 600 mA. Plug size is 2.1mm x 5.5 mm.

Power Cord Retainer: To prevent accidental pull out of the power plug.

-8-

Image 11

Contents Telex Table of Contents Table of Contents General Information Computer Controlled Channels Posi Phase DiversityAntennas Audio PowerDisplays Audio OutputUSR-100 Receiver Specifications Model SH-100 Transmitter Specifications Model LT-100 Transmitter Specifications Front Panel Rear Panel Antenna Mounting Receiver Set-upBottom View SH-100 Set-Up Battery MeterTop View Side View Back View LT-100 Microphone Connector wired as followsSet-Up System Set-Up Antenna PlacementBracket Mounting Antenna Connection Antenna Placement with Accessory Brackets and CablesAssembly of Rack Mount Installing Rack MountsDouble Mounting Model AB-2 Combination Antenna Bracket Model CLA-X 1/2 Wave AntennaOrder No Front Connector Mounting KitModel ALP-450 450-900 MHz Directional Log Periodic Antenna FCC Information Customer Service Information June