Telex USR-100 operating instructions Set-Up, Battery Meter

SH-100

Power Switch: Located on the bottom of the handle.

Battery Test Button: Press to check the remaining life of the batteries.

Battery Meter: The number of segments that light when the Battery Test Button is pushed indicate the approximate time of battery life remaining.

				Battery Meter
Number of Lights				Time Remaining	Time Remaining
				High Power	Low Power
				(alkaline batteries,	(alkaline batteries,
				intermittent usage)	intermittent usage)
4	-	3 grn	1 red	9 hours or less	12 hours or less
3	-	2 grn	1 red	7 1/2 hours or less	9 hours or less
2	-	1 grn	1 red	6 hours or less	7 hours or less
1	-	1 red		2 hours or less	2 1/2 hours or less
1	-	red flashing		1/2 hour or less	1/2 hour or less
4 lights flashing				batteries almost dead-	batteries almost dead-
				will not transmit	will not transmit

Channel Select Switches: Control the transmit channel. Must be set to match the channel of the receiver.

Microphone Gain: Controls the gain of the audio circuit to prevent under or over modulation.

Transmit Power Switch: Set to high for maximum range. Set to low to prolong battery life.

Set-Up

NOTE: Do not use carbon-zinc batteries. Ni-Cad batteries may be used but will yield shorter run times.

Unscrew the handle and install 2 “AA” size alkaline batteries. Be sure the battery polarity matches the diagram printed inside the battery holder.

Set the transmit power switch to high or low depending on the situation and requirements of the venue.

Screw the handle back on.

-11-