Telex USR-100 operating instructions Receiver Set-up, Antenna Mounting

Page 12

Receiver Set-up

Connect the supplied AC power adapter to an AC outlet supplying 105 to 125 volts AC, 60 Hz. The 230 volt export model should connect to an AC outlet supplying 210-240 VAC, 50-60 Hz.

Connect the USR-100 to your equipment:

Insert a 3 pin female “XLR” audio connector and cable into the Audio Output receptacle on the rear of the USR-100.

Insert the other end of the audio cable into the input of your Mixer/Amplifier.

Set the Audio Level Switch on the USR-100 to match the input level of your audio system.

If utilizing the two 1/4 wave antennas supplied, connect both of them to the back of the receiver at a 90angle as shown in Figure 3. Tighten the connectors securely. (If using other types of antennas, refer to the placement instructions on page 14 of this manual.)

Figure 3

Antenna Mounting

-9-

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Telex Table of Contents Table of Contents General Information Posi Phase Diversity AntennasComputer Controlled Channels Power DisplaysAudio Output AudioUSR-100 Receiver Specifications Model SH-100 Transmitter Specifications Model LT-100 Transmitter Specifications Front Panel Rear Panel Receiver Set-up Antenna MountingBottom View SH-100 Battery Meter Set-UpMicrophone Connector wired as follows Top View Side View Back View LT-100Set-Up Antenna Placement System Set-UpBracket Mounting Antenna Placement with Accessory Brackets and Cables Antenna ConnectionInstalling Rack Mounts Assembly of Rack MountDouble Mounting Model CLA-X 1/2 Wave Antenna Model AB-2 Combination Antenna BracketFront Connector Mounting Kit Model ALP-450 450-900 MHz Directional Log Periodic AntennaOrder No FCC Information Customer Service Information June
Top Page Image Contents