Telex USR-100 operating instructions Double Mounting

Page 21

Double Mounting:

Align the mid brackets (Item No. 2) with the holes on the adjacent sides of each unit.

Install the previously removed screws. Insert an additional screw (Item No. 4 provided in the parts pack) into the remaining holes. Tighten all screws securely.

Place the two assemblies side by side with the mid brackets together. (The left bracket should fit above the right so that the countersinks are visible.) Install 4 flat head screws (Item No. 5) Tighten all screws securely.

Place the assembly into the 19 inch rack enclosure and insert four #10-32 x 3/8" Phillips pan head screws (supplied) in each corner of the rack ears and secure to your enclosure.

-18-

Image 21

Contents Telex Table of Contents Table of Contents General Information Posi Phase Diversity AntennasComputer Controlled Channels Displays PowerAudio Output AudioUSR-100 Receiver Specifications Model SH-100 Transmitter Specifications Model LT-100 Transmitter Specifications Front Panel Rear Panel Antenna Mounting Receiver Set-upBottom View SH-100 Set-Up Battery MeterTop View Side View Back View LT-100 Microphone Connector wired as followsSet-Up System Set-Up Antenna PlacementBracket Mounting Antenna Connection Antenna Placement with Accessory Brackets and CablesAssembly of Rack Mount Installing Rack MountsDouble Mounting Model AB-2 Combination Antenna Bracket Model CLA-X 1/2 Wave AntennaFront Connector Mounting Kit Model ALP-450 450-900 MHz Directional Log Periodic AntennaOrder No FCC Information Customer Service Information June