Trane UX1B080A9H31B, UX1C100A9H41B, UX1B060A9H31B, UX1D120A9H51B manual BAYAIR30AVENTA BAYVENT200B

Page 21

Installer’s Guide

l

;SUPPORT HORIZONTAL PIPE EVERY 3' 0" WITH THE FIRST SUPPORT AS CLOSE TO THE FURNACE AS POSSIBLE. INDUCED DRAFT BLOWER, HOUSING, AND FURNACE MUST NOT SUPPORT THE WEIGHT OF THE FLUE PIPE.

z

COMBUSTION

AIR INLET

40" UPFLOW OR DOWNFLOW MODELS

SEE VENTING TABLE

STRAPS OR OTHER SUITABLE SUPPORTS AT MAXIMUM OF 3'-0" INTERVALS

UPWARD PITCH -- 1/4" PER FOOT

FIRST SUPPORT SHOULD BE AS

CLOSE TO FURNACE CONNECTION

AS POSSIBLE.

NOTE: ANY FITTINGS PASSING

THROUGH AN UNHEATED SPACE

MUST BE INSULATED.

NOTE: VENT AND INLET MUST BE SUPPORTED

AT A MAXIMUM OF 3' INTERVALS

USE ONLY

APPROVED

TERMINATION

OUTSIDE

WALL

STRAP (FIELD SUPPLIED)

TEE

	COMBUSTION	REDUCING
	AIR	COUPLING,
		COUPLING,
	RAIN CAP	FIELD SUPPLIED
	RAIN CAP	IF NEEDED
		IF NEEDED

VENT

COMBUSTION AIR

ELBOW (FIELD SUPPLIED)

	VENT	2", 2-1/2"
	VENT	or 3" PIPING
		or 3" PIPING
	1" + 1/2"
		3" PIPING
		SEAL ALL

BAYAIR30AVENTA

BAYVENT200B	WALL CAVITIES

18-CD22D1-8

21

Image 21

Contents Installer’s Guide Carbon Monoxide Poisoning Hazard Safety SectionInstaller’s Guide Contents Installer’s Guide UX1-H Outline DrawingDX1-H Downflow Installations Upflow InstallationHorizontal Installation Subbase Cross SectionOutside AIR is Recommended AIR for Combustion and VentilationConfined Space Return AIR Duct Systems Duct ConnectionsOptional Filter Rack Installation for BOT- TOM Return Typical Upflow Return AIR Filter InstallationsReturn AIR Filters Upflow Furnace onlyAirflow Typical Downflow Furnace Return AIR Filter Installations Alternate Upflow Filter Clip Bracket Installation KIT09224Models Cabinet Filter Numbers QTY & SizeGeneral Venting PVC Vent Fitting Material Vent Fitting Material PlasticBonding of PVC Vent and Inlet AIR Connections Horizontal VentingUpflow Furnace Inside Corner Detail Possible Configurations for TWO Pipe Venting Systems BAYVENT200B Horizontal Venting Through WallCombustible Material Wall Noncombustible Material WallBAYAIR30AVENTA BAYVENT200B Direction of Stainless Steel Fitting Downward VentingInstaller’s Guide EE Caution Used Through Chimney That Vents Another GAS ApplianceVertical Applications Condensate Drain InstructionsUpflow Vertical Horizontal ApplicationsDownflow Downflow VerticalVertical Downflow HorizontalTwinning Furnaces Electrical ConnectionsStage Heating only Thermostat Stage Heat / 1 Stage Cool Thermostat GAS PipingUpflow Left Hand GAS Piping Combustion and Input Check Orifice SizesHigh Altitude Derate Final Manifold Pressure SettingsStart UP and Adjustment Reinstallation of the Burner BOX CoverPreliminary Inspections Sequence of Operation Lighting InstructionsRoom AIR Thermostat Heat Anticipator Adjustment Airflow AdjustmentBurner BOX Temperature Limit Device Power FailureLimit switch must be reset by a qualified servicer Reset After Burner BOX Limit ShutdownIntegrated Furnace Control Error Flash Codes Trane