
Advanced Use
Transposing the entire VK-8
❍KEY TRANSPOSE (-6–0–+5)
This transposes the entire
Switching the polarity of the control pedal
❍CONTROL PEDAL POLARITY (STANDARD / REVERSE)
Depending on the type of pedal switch, the result when the switch is operated may be the opposite of what you intend. If the pedal switch does not operate as described in this owner’s manual, change the polarity setting.
Turning the [VIBRATO AND CHORUS] knob toward the right will select STANDARD, and all of the D BEAM TYPE indicators will light.
Turning it toward the left will select REVERSE, and all of the D BEAM TYPE indicators will go out.
Setting | Explanation | |
|
| |
|
| |
STANDARD | Use this setting if the pedal switch oper- | |
ates as described in this owner’s manual. | ||
| ||
|
| |
REVERSE | Use this setting if the pedal switch pedal | |
operates the opposite of the description in | ||
| this owner’s manual. | |
|
|
Switching the polarity of the Hold pedal
❍HOLD PEDAL POLARITY (STANDARD/ REVERSE)
Depending on the type of pedal switch, the result when the switch is pressed may be the opposite of what you intend. If the pedal switch does not operate as described in this owner’s manual, change the polarity setting. Turning the [VIBRATO AND CHORUS] knob toward the right will select STANDARD, and all of the D BEAM TYPE indicators will light.
Turning it toward the left will select REVERSE, and all of the D BEAM TYPE indicators will go out.
Setting | Explanation | |
|
| |
|
| |
STANDARD | Use this setting if the pedal switch oper- | |
ates as described in this owner’s manual. | ||
| ||
|
| |
REVERSE | Use this setting if the pedal switch oper- | |
ates the opposite of the description in this | ||
| owner’s manual. | |
|
|
Parameters that are stored in a preset
■Effect and Other Settings
1.Hold down the HARMONIC BAR PART [UPPER] and [PEDAL] buttons, and press the [PRESET] button.
The indicators of buttons
2.Press one of the
There are five
The following parameters are assigned to each button.
Button | Parameter | Page |
|
|
|
|
|
|
[1] | REVERB TIME | p. 57 |
|
|
|
[2] | OTHER TONES CHORUS LEVEL | p. 57 |
|
|
|
[3] | OTHER TONES OCTAVE SHIFT | p. 57 |
|
|
|
[4] | HOLD PEDAL ASSIGN | p. 57 |
|
|
|
[5] | D BEAM ROTARY SPEED MODE | p. 57 |
|
|
|
3.Turn the [VIBRATO AND CHORUS] knob to adjust the setting.
If you press the VIBRATO AND CHORUS [ON] button, the setting will return to its initial value.
4.If you want to edit another parameter, press the appropriate button from [1] through [5] to select the parameter, and turn the [VIBRATO AND CHORUS] knob to adjust the setting.
When you want to stop editing, press the HARMONIC BAR PART [UPPER] button.
5.Press the [WRITE] button to finalize the settings of the
6.Save the finalized parameter settings in a preset (p. 45).
NOTE
Never turn off the power while preset are being saved.
56