Teac WR-DA7 manual Midi Sequencer Performer Setup, ADAT, BRC Setup

To use Control Change, set [Tx, Rx] and NRPN to [ON] in the CTRL CHG setup area of the MIDI Setup Window.

To use System Exclusive set [Tx, Rx] to [ON] in the System EX setup area of the MIDI setup Window.

MIDI Sequencer (Performer) Setup

To operate Performer in synchronization with the timecode of the BRC, select [Modem] with [Receive Sync] and [MTO, DTL, or DTLe] with the [Type of Sync] in the Basic menu of Performer. Then select the frame-rate with the [SMPTE Frame Format] to match the frame-rate of the time- code that’s being received.

To record WR-DA7 operation on the MIDI sequencer (Performer), start [Patch Thru] in the Basic menu and set [Select Patch Thru Mode] to [OFF] so the MIDI sequencer will not echo MIDI mes- sages.

To set Performer to slave mode, select [Slave to External Sync] in the Basic menu. Then, select [Control Panel] in the Windows menu of Performer, then press the [PLAY] and [REC] buttons in the open window so Performer will stand by to receive timecode.

ADAT, BRC Setup

With the BRC serving as the wordclock master, select [Fixed Mode] to select a sampling rate of 48 kHz, or select [Variable Mode] to select a sampling rate of 44.1 kHz. Then press the [Pitch Down] switch to set -147 cent ([44.1] shown on the screen).

MTC setup, set MIDI to [MTC] in the Gen Sync setup menu, and press the [Gen Sync] switch to [ON].

To output timecode from the BRC during ADAT FF/REW, set item 8 [Output Rew/FF SMPTE & MTC] on the BRC MIDI/UTIL setup menu to [ON].

To operate the MMC, the MMC and MIDI channels of the WR-DA7 and BRC must be set the same. On the BRC, set items 11 [MIDI Device] on the MIDI/UTIL setup menu to "the MIDI channel set by the WR-DA7 minus 1" or [ALL].

44