Teac WR-DA7 manual

To enable the DA-98 to receive digital input from the TDIF-1, press the DIGITAL IN button on the front panel.

When the timecode output of the video recorder is generated after being converted to MTC, the MODE dip switch 6 on the SY-88 rear side is set to OFF. (If this switch is set to ON, the timecode recorded on the tape is converted into MTC and the resultant output is generated.)

Use the tape where the recorded timecode has the same frame rate as that of the SMPTE timecode output generated from the video. It is impossible to perform operation synchronized with the SMPTE timecode of the video recorder if no timecode is recorded in the tape or there is failure in coincidence of the frame rate.

Turn on the CHASE switch of the DA-98.

Set the dipswitch 8 at ON the SY-88 board.

While ALL INPUT is ON; no playback is generated. To realize playback, ALL INPUT should be set to OFF.

A ‘CHANNEL STATUS CRCC ERROR’ may be displayed during Digital recording from the DA7.

This is; however, a message in regards to the sub-code signal, even with this being displayed proper audio recording and playback should be performed.

38