INSTALLATION
POWER CORD CHANGEOVER
DANGER: Risk of electrical shock. Disconnect power before servicing appliance. Do not route power cord under or in front of appliance.
To change the power cord from one side of insert to the other, perform the following steps:
1.Ensure power cord in NOT plugged in.
2.Remove the louver blower panels on each side of fuel door as follows. Each panel is held in place by two ¼” (7 mm) head screws. Using a ¼” (7 mm) socket or nut driver, remove the screws
3.Remove panels by pulling them outward slightly then forward.
4.Locate terminal block on right side of appliance. Write down the locations where the black, white and green leads from the power cord are attached to the terminal block. Disconnect these three wires then re- install them onto the terminal block on the left side of appliance in the same corresponding positions (as you had written down).
5.Reinstall panels.
BAFFLE PLATE
This appliance has a very heavy (60 lbs [27 kg]) 3/8" (9.5
mm)thick steel baffle that is installed directly above the secondary air tubes in the firebox. To inhibit the baffle plate from shifting during shipment, a packing block is installed at the factory (see illustration below). The pack- ing block needs to be removed prior to burning your in- sert. During installation, the baffle may slide forward, and must be repositioned (pushed to the back) in order for the insert to operate properly. When in its proper posi- tion, the rear flange of the baffle plate should be flush to the back wall of the firebox.
MARBLE
Marble is a natural product and therefore each piece will have its own unique character. Marble can be scratched so care should be taken to avoid putting heavy or rough objects (trivet / steamers) on the surface. Do not install the marble before curing the paint.
The ceramic fiber blanket and cerawool strips provided with appliance must be placed under the marble to insu- late it from the high temperatures on top of the firebox. Do not place the marble directly on the top metal surface of the stove or it will crack.
INSTALLATION STEPS
1.Remove all ashes from the fireplace.
2.Remove all materials inside the insert and set them aside.
3.Remove the
4.Use a large piece of cardboard or other protective material and place it in front of the fireplace to protect floor or carpet during installation.
5.Remove the insert from its wood pallet by removing the screws.
6.Prepare chimney connection system as specified for ma- sonry or zero clearance fireplaces.
7.Set the insert on the protective cardboard laid out in front of the fireplace centered in front of the fireplace opening.
8.(Masonry Fireplace) Slide insert into the fireplace far enough to attach the starter pipe or positive flue connection (a mini- mum of a 6" (152 mm) starter pipe extending past the header is required). See * note, page 11.
9.(Factory Built Fireplace – USA only) Slide insert into the fire- place far enough to attach connector to flue outlet. See * note, page 11.
PAGE 9