Peavey RQ 4300 Series manual Super Channels, Stereo Channels, Channel Fader, Polarity

Page 7

LED in the MONO MASTER section (45) will blink to indicate that the signal on the MONO LED display and at the headphone out is PFL. Selecting PFL allows the operator to monitor a channel even with the channel muted, and is especially useful for cueing CDs/tapes. When the PFL button is in the out position, the yellow channel LED will blink as an indication of signal presence (-20 dBu).

(16)CHANNEL FADER

This control varies the signal level sent from the channel to the L/R, SUB, and/or MONO master channels from (– ∞) to +10 dB. The 0 position is unity gain, meaning no increase or decrease in the level set by the GAIN control (4), and is the optimum setting for this control. If the level is too quiet or too loud at unity gain on the FADER, the channel GAIN (4) may need to be adjusted.

22

0 dB -20 dB

PAD

NORMAL

REVERSED

POLARITY

LINE

(BAL)

MIC (BAL)

21

0 dB

 

 

 

 

 

 

 

17

-20 dB

 

 

 

 

PAD

 

 

 

NORMAL

REVERSED 18

POLARITY

LINE

(BAL)

MIC(BAL)

SUPER CHANNELS

[CHANNELS 21–22 (RQ 4324) AND 29–30 (RQ 4332)]

Input connections and channel strip controls on SUPER CHANNELS are the same as STANDARD CHANNELS with the exception of INSERT jacks. In place of INSERT connections, SUPER CHANNELS are equipped with:

(17)PAD

This switch attenuates (reduces) the input signal by 20 dB. This allows accommodation of higher input levels without clipping and is especially useful when close-miking high sound pressure level (SPL) sources such as drums or guitar cabinets. It is also beneficial for “hot” line sources such as keyboards and some wireless microphones.

(18) POLARITY

 

24s

23s

This switch reverses the polarity of both the XLR and LINE input

 

connectors to compensate for an out-of-phase signal that would

 

LEFT

LEFT

otherwise cause frequency (phase) cancellations in the mix.

 

 

 

STEREO CHANNELS

19

 

 

[CHANNELS 23–24 (RQ 4324)

RIGHT

RIGHT

 

 

 

AND 31–32 (RQ 4332)]

 

 

 

STEREO CHANNELS offer the same channel strip controls as STANDARD

MIC (BAL)

MIC (BAL)

CHANNELS with the exception of the MID FREQ control (8). Center

 

 

 

bandpass frequency is set at 850 Hz. In place of the MID FREQ control,

 

 

 

STEREO CHANNELS offer independent gain controls for LINE and MIC

 

 

 

(XLR).

 

 

 

(19) STEREO 1/4" LINE INPUTS

 

LEFT

LEFT

These TS jacks are unbalanced line-level inputs for stereo (L/R)

 

INPUT

INPUT

signals. They are connected in parallel with the STEREO RCA 20

 

 

LINE INPUTS (20). If you have a MONO line source, use a Y

 

RIGHT

RIGHT

cable or one of the channels with a MONO line input.

 

INPUT

INPUT

 

 

 

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents 4300 Series Page Explanation of Terms IntroductionUnpacking Connector WiringMIC Rear Panel ConnectionsInsert LineMID Freq Polarity Super ChannelsStereo Channels Channel FaderStereo RCA Line Inputs Master SectionCompressors Master Section Features and Controls AUX SendsMute SWITCH/MUTE-CLIP LED AFL SWITCH/AFL-SIGNAL LEDMUTE/MUTE LED ThresholdSUB Groups LEFT, RIGHT, Mono Output AssignLEFT/RIGHT Level Displays Phantom PowerHeadphone Output Headphone LevelRear Panel Connections Compressor I/O INPUT/OUTPUT PowerRemovable Power Cord Power SwitchBlock Diagram Left, Center, Right Configuration Stereo Configuration RQ 4324 and 4332 Sound Reinforcement Mixer Total Harmonic Distortion THD Output SpecificationsEquivalent Input Noise EIN Signal / Overload IndicatorsLamp Power Power RequirementsExplicación DE LOS Términos IntoducciónCableado DE Conectadores Controles DE LOS Canales Ganancia DesempaqueLínea MicroEQ Agudo Fader DE Canal Super CanalesInterruptor DE Mute Interruptor DE PFL/LED DE Señal PFLEntradas DE Línea DE 1/4 Estéreo Canales EstéreoEntradas DE Línea Estéreo RCA Nivel Sección Maestra24 I/O DEL Compresor LED DE MUTE/SATURACIÓNLED DE AFL CompresoresMUTE/ LED DE Mute UmbralSUB Grupos LED DE Nivel IZQUIERDO, Derecho Y Mono Asignación DE SalidaPoder Phantom Corte DE Graves36 1/2, 3/4, L/R, Mono Asignaciones Interruptor AFL/LED DE AFLMuestra DE Nivel Mono AFL/PFL Salida DE AuricularesNivel DE Auriculares Medidores IZQUIERDO/DERECHOConexiones DEL Panel Trasero Corriente Explication DES Termes FrançaisDeballage Standarts DE ConnexionMIC Connections Panneau ArriereMID Freq Entrees Stereo LIGNE-JACK PFL SWITCH/SIGNAL-PFL LEDSupers Canaux Canaux StereoEntrees Stereo LIGNE-RCA Section MasterMute SWITCH/MUTE-CLIP LED Gain Reduction Leds Leds de niveau de perte de gain Returns Rear Panel Connections Power Erklärung DER Begriffe EinleitungPage Kanäle 1-20 RQ 4324 UND 1-28 RQ Verdrahtung DER SteckerAuspacken StandardkanäleKANAL-SCHIEBEREGLER 11 AUX PFL-Schalter/SIGNAL-PFL-LEDMUTE-SCHALTER/MUTE-CLIP-LED Stereo RCA LINE-EINGÄNGE Super ChannelsStereo Channels Stereo 1/4 LINE-EINGÄNGEFunktionen UND Regler DER MASTER-STUFE AUX Sends Phantom PowerKompressoren AFL-SCHALTER/AFL-SIGNAL-LED32 AFL/AFL-LED Gain REDUCTION-LEDsLEVEL-LEDs MUTE/MUTE-LEDAUX 1 und AUX Mono AFL/PFL LEVEL-ANZEIGE LEFT/RIGHT LEVEL-ANZEIGEN50 L, R, Mono Unbal Unsymmetrierter Ausgang POWER-LED47 L & R Master Fader Anschlüsse AN DER Rückseite 49 L, R, Mono InsertStromversorgung Abziehbares Stromkabel Compressor I/O EINGANG/AUSGANGAUX 1-6 OUT Unsymmetriert AUX 1-4 OUT SymmetriertPage Peavey Electronics Corporation Limited Warranty Important Safety Instructions 2001

RQ 4300 Series specifications

The Peavey RQ 4300 Series is a versatile line of ultra-reliable mixing consoles designed to cater to a wide range of audio needs. Whether for live performances, studio recording, or installation in various venues, the RQ 4300 Series delivers exceptional audio quality and user-friendly features. One of the leading characteristics of this series is its robust construction, engineered to withstand demanding environments while ensuring longevity and stability.

At the heart of the RQ 4300 Series is a comprehensive input system that includes multiple channels with XLR and line inputs. This allows for seamless connections to microphones, instruments, and other audio sources. Each channel features a three-band EQ, giving users fine control over their audio mix. The EQ enables adjustments to boost or cut frequencies, assisting sound engineers in achieving the perfect tonal balance.

One standout feature of the RQ 4300 is its built-in effects processor. This processor offers a variety of effects ranging from reverb to delay, allowing users to enhance their sound without needing external effects units. This all-in-one approach simplifies the setup and reduces clutter in performance spaces or studios.

Additionally, the series incorporates Peavey’s high-quality preamps, known for their clarity and low noise levels. This ensures that every detail of the audio source is captured accurately, whether it's a subtle vocal nuance or the richness of an acoustic instrument. The RQ 4300’s dynamic range guarantees minimal distortion, maintaining audio fidelity throughout performances.

Another significant characteristic is the intuitive layout of controls. The console is designed for ease of use, with clear labeling and ergonomically placed faders and knobs. This user-centric design allows sound engineers to operate the console confidently, even during high-pressure situations like live shows.

Connectivity is further enhanced by the inclusion of stereo outputs, aux sends, and subgroups, which facilitate various routing options for mixed audio. This versatility supports diverse applications, making the RQ 4300 ideal for both novice users and experienced professionals.

In conclusion, the Peavey RQ 4300 Series stands out as a dependable choice for anyone in the audio industry. With its combination of rugged build quality, sophisticated features, and intuitive design, it empowers users to deliver outstanding sound in any setting. Whether for live sound reinforcement, studio tracking, or installation, the RQ 4300 is tailored to meet the demands of modern audio production.
Top Page Image Contents