Power Amplification Section

RATED POWER AND LOAD:

120 W RMS into 16, 8, or 4 ohms

POWER @ CLIPPING:

(Typically @ 5% THD, 1 kHz, 120 V AC line)

130 W RMS into 16, 8, or 4 ohms (Bias must be reduced to measure.)

FREQUENCY RESPONSE:

+0, -3 dB, 50 Hz to 20 kHz @ 100 W RMS into 8 ohms

HUM AND NOISE:

Greater than 75 dB below rated power

POWER AMP EQ:

Active Presence: +10 dB @ 2 kHz

Active Resonance: +10 dB @ cabinet resonant frequency

POWER CONSUMPTION (Domestic):

400 watts 50/60 Hz, 120 V AC (Domestic)

TUBE COMPLEMENT:

5150® II

SPECIFICATIONS PREAMP SECTION

The following specs are measured @

1 kHz with the controls preset as follows: Low and High EQ @ 10

Mid EQ @ 0 Bright out

Lead and Rhythm Posts @ 10

Presence and Resonance @ 0 dB Nominal levels with Pre Gains @ 5 Minimum levels with Pre Gains @ 10

PREAMP INPUT:

Impedance: Very high Z, 470K ohms

Lead Channel (with channel select in): Nominal Input Level: -60 dBV,

1 mV RMS

Minimum Input Level: -76 dBV,

.15 mV RMS

Clean Channel (with channel select out): Nominal Input Level: -30 dBV,

30 mV RMS

Minimum Input Level: -34 dBV,

20 mV RMS

Maximum Input Level: 0 dBV,

1.0 V RMS

(Subtract 24 dB with Crunch switch in.)

EFFECTS RETURN:

Impedance: Very High Z, 470 k ohms

Designed Level: -10 dBV, 300 mV RMS

PREAMP OUT:

Load Impedance: 47 k ohms or greater

Nominal Output: +10 dBV, 3 V RMS

REMOTE FOOTSWITCH:

Special 3-button unit with LED indicators (supplied)

Channel select and reverb

SYSTEM HUM AND NOISE @ NOMINAL LEVEL (clean channel):

(20 Hz to 20 kHz unweighted) Greater than 63 dB below rated power

EQUALIZATION:

Custom Low, Mid, and High passive type EQ

Push Bright (Rhythm Channel only) +6 dB @ 2 kHz

Push Crunch (Rhythm Channel only) Increases gain

DIMENSIONS (H x W x D):

10" x 26.625" x 11.75"

(25.4 cm x 67.6 cm x 29.8 cm

6-12AX7 preamp tubes

(1 for clean/crunch, 3 for Lead, 1 for EFX and 1 phase splitter 4-6L6GC

EFFECTS SEND:	WEIGHT:
Load Impedance: 47 k ohms or greater	48.3 lbs. (21.91 kg)
Nominal Output: -10 dBV, 300 mV RMS

Features and specifications subject to change without notice.