Peavey BAM 210 operation manual Preset Definition

PRESET DEFINITION

Address	Name	Range (Decimal)
(Hex)
00	Model Selection	High nib is Cabinet Model, 0-7
		Low nib is Amp Model, 0-7
		Clockwise rotation for both nibs:
		0 = Red / 2x10
		1 = 360 / 1x18
		: : :
		7 = Freddie K / Alloy 4x10
01	Hardware Control Bits	0-3,7 = <reserved>
		4 = Compressor On
		5 = Analog Overdrive On
		6 = Tweeter On
02	<reserved>	0
03,04	Pre Gain (non-boost, boost)	1-33 (active when Analog Overdrive
		enabled)
05,06	Low (non-boost, boost)	1-33
07,08	Mid (non-boost, boost)	1-33
09,0A	Mid Shift (non-boost, boost)	1-33
0B,0C	High (non-boost, boost)	1-33
0D,0E	Post Gain (non-boost, boost)	0-33 (0 = reverb off)
0F,10	<reserved>	0
11,12	Speed/Adj (primary/off, secondary/on)	1-25
13,14	Depth (primary/off, secondary/on)	0-25 (0 = modulation off)
15	Effect Type	0-7 = Chorus, Flanger, Phaser,
		Octave, Synth, Fretless, Funk Wah,
		Distortion
16	Effect Tweak 1	1-25; 255=no tweak *(see below)
17	Effect Tweak 2	1-25; 255=no tweak *(see below)
18-1D	<reserved>	0
1E	EFX Mode Status Bits (Soft)	High nib is <reserved>
		Low nib is EFX mode status:
		Bit 0 is Boost (on/secondary = high)
		Bit 1 is <reserved>
		Bit 2 is Effect On (on = high)
		Bit 3 is Effect Alt. (on/secondary = high)

Values are automatically set with effect selection, adjust after to tweak. Available tweaks are shown in table below.

	Tweak 1	Tweak 2
Chorus	-	Crossover Frequency
Flanger	Delay Time	Crossover Frequency
Phaser	-	-
Octave	Tone	-
Synth	Frequency	Resonance
Fretless	Frequency	Resonance
Funk Wah	Frequency	Resonance
Distortion	Low Rolloff	Dry Level

38