GE X-9 Program EQ Q, Values, Meter release time, Meter peak hold, Time, Digital out, Curve

				5 Menus
Function	Menu	Meaning	Available settings	Notes
	display
Program EQ Q	11_E	Sets the Q value for the	After pressing ENTER to	Use the left menu sys-
values		EQ bands of the	select the menu, use the dial to	tem for programs 1 and
		selected program (see	select the band (H=high,	3.
		“EQ Q setting” on	M*=mid, L=low) and press	Use the right menu sys-
		page 28)	ENTER.	tem for programs 2 and
			A low value of Q	4.
			nOr Normal value of Q
			B high value of Q
			Value changes as selection is
			made. Press ENTER to con-
			firm.
Meter release time	12Mr	Sets the meter release	nor* Normal	Can be performed on
		time (see “Adjusting the	SLO Slow	both left and right menu
		output volume” on		systems.
		page 16).
Meter peak hold	13MP	Sets the meter peak	All values are in seconds	Can be performed on
time		hold time (“Adjusting the	OFF	both left and right menu
		output volume” on	05.	systems.
		page 16)	10. *
			20.
Digital out	14dI	Sets whether the signal	nOr* Post-fader signal	Can be performed on
		from the digital output is	rEc Pre-fader signal	both left and right menu
		pre- or post master		systems.
		fader
Program fader	15Fc	Sets the fader curve as	After pressing ENTER to	Can be performed on
curve		described and shown in	select the menu, use the dial to	both left and right menu
		“Program fader “curve””	select the program fader to be	systems.
		on page 21.	set (1, 2, 3 or 4) and press
			ENTER.
			Select from the following:
			A1 –6 dB
			nOr* –12 dB
			A2 –24 dB
			Press ENTER to confirm.
Program fader	16Fr	Sets the fader direction	After pressing ENTER to	Can be performed on
reverse		to reverse as described	select the menu, use the dial to	both left and right menu
		in “Program fader direc-	select the program fader to be	systems.
		tion” on page 21.	set (1, 2, 3 or 4) and press
			ENTER.
			Select:
			NOr* Normal
			rEV Reverse
			Press ENTER to confirm.
Sampler tempo	17St	Sets the sampler play-	After pressing ENTER to	Can be performed on
		back pitch for either	select the menu, use the dial to	both left and right menu
		sampler 1 or sampler 2.	select the sampler to be set	systems.
			(S1*, or S2) and press	When sampler data is
			ENTER.	erased, the value is
			Use the dial to select the value	reset to 0%.
			(from -100to100) and press
			ENTER to confirm.

TASCAM X-9Owner’s Manual 19